Abstract:This article studies the switching performance of vertical GaN power FinFETs and proposes new interfin designs to improve it. The interfin region has been found to be an important limiting factor for FinFET switching performance. The time taken to (dis)charge the dielectric parasitic capacitances and drift layer in the interfin regions severely limits the device turn-(on)off speed. Three new interfin designs are proposed, based on reduced fin-to-fin spacing, oxide full-filling (FF), and split-gate (SG) structures. The 1.2-kV, 80-mΩ vertical GaN FinFETs with these designs were evaluated by a well-calibrated device-circuit mixed-mode technology computer-aided design (TCAD) simulation. Both the reduced-fin-spacing structure and the oxide FF reduce the dielectric parasitic capacitances, but only lead to small reduction (less than 10%) in switching losses. Much better improvement is obtained with the SG structure, which removes the gate metal in the interfin region and exposes the drift layer to the field lines from the source metal. During the turn-(on)off of the transistor with a SG structure, the drift layer underneath the interfin gap region is (dis)charged by a combination of the drain-to-source and gate currents, leading to shorter switching times and lower switching losses. By utilizing the SG structure, simulations predict a 58% improvement in the switching figure-of-merit and 38% lower switching losses in 1.2-kV vertical gallium nitride (GaN) power FinFETs. These results provide key understanding and design guidelines for power FinFETs. Finally, an 800-V buck converter using a 1.2-kV GaN FinFET half-bridge module is simulated, showing excellent efficiency when operating at a multi-MHz frequency and revealing the requirement for device thermal management. This highlights the great potential of vertical GaN power FinFETs for future high-frequency medium-voltage power applications.

Maximizing the voltage and current capability of GaN FETs in a hard-switching converter

A 2–10 MHz GaN HEMTs Half-Bridge Driver with Bandgap Reference Comparator Clamping and Dual Level Shifters for Automotive Applications

25.2 A 10mhz 3-to-40v VIN Tri-Slope Gate Driving GaN DC-DC Converter with 40.5dbµv Spurious Noise Compression and 79.3% Ringing Suppression for Automotive Applications

A Unified Switch Loss Model and Design Consideration for Multilevel Boost PFC with GaN Devices

A Normalized Quantitative Method for GaN HEMT Turn-ON Overvoltage Modeling and Suppressing

Maximizing the performance of 650 V p-GaN gate HEMTs: Dynamic ron characterization and gate-drive design considerations

FoM Based Optimal Frequency and Voltage Level Design for High Efficiency High Density Multilevel PFC with GaN Device

An Up to 10mhz 6.8% Minimum Duty Ratio GaN Driver with Dual-MOS-Switches Bootstrap and Adaptive Short-Pulse Based High-CMTI Level Shifter Achieving 6.05% Efficiency Improvement

A 1-Mhz ZVS Boost DC-DC Converter with Active Clamping Using GaN Power Transistors

An 8A 998A/inch<SUP>3</SUP> 90.2% Peak Efficiency 48V-to-1V DC-DC Converter Adopting On-Chip Switch and GaN Hybrid Power Conversion

A Monolithic GaN Driver and GaN Power Switch with Power-rail Charging Saturation Bootstrap technique achieving gate rising and falling time ratio of 1.28

Maximizing the Performance of 650-V P-Gan Gate HEMTs: Dynamic RON Characterization and Circuit Design Considerations

Comparisons on Different Innovative Cascode GaN HEMT E-Mode Power Modules and Their Efficiencies on the Flyback Converter

A High-reliability Half-Bridge GaN FET Gate Driver with Advanced Floating Bias Control Techniques

AlGaN/GaN Metal-Insulator-Semiconductor (Mis)-Hfets Based DC-DC Boost Converters with Integrated Gate Drivers

Switching Performance Analysis of Vertical GaN FinFETs: Impact of Interfin Designs

Threshold voltage modulation on a CTL-based monolithically integrated E/D-mode GaN inverters platform with improved voltage transfer performance

Monolithically Integrated Power Converter Based on Etching-Free P-Gan HEMTs by Hydrogen Plasma Treatment Technology

Quantifying Dynamic On-State Resistance of GaN HEMTs for Power Converter Design via a Survey of Low and High Voltage Devices

Consideration of flyback converter using GaN devices

Monolithic Integration of Gate Driver and Protection Modules with P-GaN Gate Power HEMTs