Evaluation Of Electrical And Mechanical Characteristics For A Twisted Soldered-Stacked-Square (3s) Hts Wire With 1 Mm Width

Z. Y. Li,Y.Q. Li,Mingyang Wang,D. M. Xi,Jianwen Zhang,Y. H. Ma,Z. Hong,Z. Jin,K. Ryu

DOI: https://doi.org/10.1109/TASC.2017.2788402

IF: 1.9489

2018-01-01

IEEE Transactions on Applied Superconductivity

Abstract:Because of the small square dimension, a soldered-stacked-square (3S) high-temperature superconducting (HTS) wire with 1 mm width is considered as a candidate for cabling large current conductors through twist process. For studying the twist structure, in this work, we prepared several twisted 3S wire samples fabricated from the same piece of the 3S wire with 10 m length. For the 3S wire, the uniformity of critical current was evaluated. As well, we investigated basic electrical and mechanical characteristics for the twisted 3S wire. The main results show that the critical current distribution for the 3S wire is relatively uniform at the average value of 90 A; the allowable minimum twist pitch of the twisted 3S wire is about 60 mm; the critical current of the twisted 3S wire shows isotropy characteristics; through the test for frequency dependence of self-field loss, we can know the eddy-current loss in the twisted 3S wire can be ignored, and the measured losses are identical to the calculated one from the thin strip equation; the minimum bending diameter and allowable tensile force for the twisted 3S wire are approximately 80 mm and 400 N, respectively.