Abstract:Silicon -based ultra -thin flat heat pipes (UFHPs) that can be integrated with semiconductor devices provide an opportunity for electronic thermal management. To meet the requirements of various operation states, the impacts of gravity on the liquid plug characteristics and heat transfer performance of an UFHP are investigated by a visualization experiment conducted at different incline angles. Condensate flows back through microgrooves under the capillary pressure and gravity under a low heating power (capillary flow stage), and then excess condensate flows back along the edges of the UFHP under a higher heating power (gravitational flow stage). Over a certain heating power ( Q >= 14 W), liquid plug fluctuations caused by vapor entrainment are observed with periodic dry -out at the evaporator under large incline angles ( alpha >= 60 degrees ), corresponding to temperature fluctuations. Intense fluctuations of the liquid plug enhance sensible heat transfer, although the liquid plug occupies the condenser area and impedes the vapor flow. Meanwhile, evaporation at the evaporator benefits from corner -film evaporation until a large area of dry -out occurs. Due to the increased gravity and buoyancy, a larger incline angle is conducive to thermal performance enhancement, but this effect becomes restricted as the heating power rises. At a cooling -water temperature of 20 degrees C and an incline angle of 90 degrees , the lowest thermal resistances of the UFHP yield a value of 1.14 degrees C/W at 4 W in the steady stage and a value of 1.22 degrees C/W at 18 W in the fluctuation stage, respectively. The heat transfer limit of UFHP with overfilling reaches 24 W, compared with the theoretical heat transfer capacity of 8.9 W at an incline angle of 90 degrees . Additionally, a higher cooling -water temperature is beneficial for the thermal performance in the capillary flow stage, but not in the gravitational flow stage and fluctuation stage. This study provides guidance for the operational design of silicon -based UFHP for electronic thermal management.

Effects of Filling Ratio and Condenser Temperature on the Thermal Performance of a Neon Cryogenic Oscillating Heat Pipe

Experimental Investigation on the Performance of a Neon Cryogenic Oscillating Heat Pipe

Study on a Neon Cryogenic Oscillating Heat Pipe with Long Heat Transport Distance

Experimental Investigation of the Characteristics of Cryogenic Oscillating Heat Pipe

NUMERICAL INVESTIGATION OF THERMAL PERFORMANCE OF A CRYOGENIC OSCILLATING HEAT PIPE

Experimental Investigation on the Heat Transfer Performance and Evaporation Temperature Fluctuation of a New-Type Metal Foam Multichannel Heat Pipe

Numerical Investigation on Pulsating Heat Pipes with Nitrogen or Hydrogen

Experimental investigation on a pulsating heat pipe with low number of turns at liquid hydrogen temperature range

Numerical Study of the Thermal Performance of a Hydrogen Pulsating Heat Pipe

Numerical investigation on cryogenic pulsating heat pipes with nitrogen

Cryogenic Oscillating Heat Pipe for Conduction-Cooled Superconducting Magnets

Experimental and Theoretical Study on Operation Characteristics of an Oscillating Heat Pipe

Experimental Study on a Hydrogen Closed-Loop Pulsating Heat Pipe with Two Turns

Modeling and numerical investigation on the effects of filling ratio in a large separate heat pipe loop

Liquid Plug Characteristics and Heat Transfer Performance of a Silicon-Based Ultra-Thin Flat Heat Pipe at Different Incline Angles

Investigation on the temperature dependence of filling ratio in cryogenic pulsating heat pipes

Effects of filling ratio, geometry parameters and coolant temperature on the heat transfer performance of a wraparound heat pipe

Heat Transport Capability and Fluid Flow Neutron Radiography of Three-Dimensional Oscillating Heat Pipes

Thermal Performance of an Oscillating Heat Pipe with Al2O3–water Nanofluids

Impact of Cooling Condition and Filling Ratio on Heat Transfer Limit of Cryogenic Thermosyphon

Design And Performance Analysis Of Small Cryogenic Heat Pipes As Thermal Links For Cryocoolers