Abstract:The heat transfer performance of a cryogenic heat pipe using N2-Ar binary mixture as working fluid is experimentally studied and discussed in this paper.Heat pipe is a high efficiency heat transfer device by utilizing the liquid-vapor latent heat of working fluid,but the disadvantage is that the operational temperature range of heat pipe is limited by the triple point and critical point of working fluid.While,wide operational temperature range is required in some cases,especially in the cryogenic field referring to the cooling down process from room temperature to ultra-low temperature.In order to study the heat transfer performance of the cryogenic heat pipe using mixture as working fluid,an experimental setup is established,in which the liquid nitrogen at atmospheric pressure and resistive heating wire wound around the evaporator act as the heat sink and heat source,respectively.The working fluid is charged into the cryogenic heat pipe by a safe and effective method,without high charging pressure and complex equipment.The filling ratio in the experiments is 1.0.The temperature distribution along the entire cryogenic heat pipe and the inner pressure are measured during the experiments.These parameters are recorded after the entire cryogenic heat pipe reaches a steady state under a certain heating power,and the heating power applied on the evaporator is increased step-wisely until the heat transfer limit of the cryogenic heat pipe,which is signified by the abrupt rise of the evaporator temperature.The heat transfer performances of the cryogenic heat pipe with pure-N2,pure-Ar and N2-Ar binary mixture working fluid are tested in the experiments,and the results of different working fluids are compared with each other.It is found that the cryogenic heat pipe with mixture working fluid has wider operational temperature range than that of the two pure working fluid cases,and the thermal resistance of the cryogenic heat pipe with mixture working fluid is lower than that of the pure-Ar case and higher than that of the pure-N2 case.The heat transfer limit of the cryogenic heat pipe with the mixture working fluid is the same as that of the pure-Ar case,e.g.160 W,higher than that of the pure-N2 case,e.g.110 W.

Study on a Neon Cryogenic Oscillating Heat Pipe with Long Heat Transport Distance

Experimental Investigation on the Performance of a Neon Cryogenic Oscillating Heat Pipe

Experimental Investigation of the Characteristics of Cryogenic Oscillating Heat Pipe

Effects of Filling Ratio and Condenser Temperature on the Thermal Performance of a Neon Cryogenic Oscillating Heat Pipe

Experimental Study on a Hydrogen Closed Loop Pulsating Heat Pipe with Different Adiabatic Lengths

NUMERICAL INVESTIGATION OF THERMAL PERFORMANCE OF A CRYOGENIC OSCILLATING HEAT PIPE

Investigation on the Influence of Different Heat Transmission Distances on Thermo-Hydrodynamic Characteristics of Pulsating Heat Pipes

Transient Numerical Model on the Design Optimization of the Adiabatic Section Length for the Pulsating Heat Pipe

Experimental Investigation on the Heat Transfer Performance and Evaporation Temperature Fluctuation of a New-Type Metal Foam Multichannel Heat Pipe

Cryogenic Oscillating Heat Pipe for Conduction-Cooled Superconducting Magnets

Experimental investigation on a pulsating heat pipe with low number of turns at liquid hydrogen temperature range

Numerical investigation on cryogenic pulsating heat pipes with nitrogen

An experimental investigation on oscillating heat pipe under trans-critical conditions

Numerical Study of the Thermal Performance of a Hydrogen Pulsating Heat Pipe

Numerical Investigation on Pulsating Heat Pipes with Nitrogen or Hydrogen

Experimental and Theoretical Study on Operation Characteristics of an Oscillating Heat Pipe

Experimental Study on a Hydrogen Closed-Loop Pulsating Heat Pipe with Two Turns

Heat Transport Capability and Fluid Flow Neutron Radiography of Three-Dimensional Oscillating Heat Pipes

Experimental Study on a Helium Cryogenic Closed Loop Two-Phase Thermosyphon with a Long Heat Transport Distance

Heat transfer performance of cryogenic heat pipe with binary mixture working fluid

Design of a Hydrogen Pulsating Heat Pipe