Abstract:Accurate measurement of CO2 generated from different emission sources is the basis for controlling CO2 emissions and mitigating global warming. With advantages of high accuracy and rapid response, isotope analyzers using spectroscopic techniques, particularly those using cavity ring-down spectroscopy, have been widely used for CO2 emissions monitoring. However, these analyzers often face challenges such as spectral interference from impurity gases and unstable temperature control within the optical cavity in isotope analyzers. To address these challenges, this paper proposes a low-temperature optical cavity scheme utilizing a split Stirling-type pulse tube cryocooler. Combining thermal boundary conditions with particle swarm optimization, a dynamic cooling and temperature control model of the optical cavity was established in MATLAB. The model subsequently analyzed the cooling process, temperature control, and stability of the optical cavity. After 120 h, the simulations showed that the central part of the optical cavity had cooled to 126.4 K with a heat leakage of 8.90 W, in agreement with the experimental results that stabilized at 126.8 K. The temperature fluctuations remained within 0.1 K/h while controlling an overall temperature of 170 K with a temperature difference of +/- 5 K. Changes in the electrical input power of cryocooler had no influence on the temperature distribution. This advancement not only lowers the operating temperature of the optical cavity to minimize spectral interference but also enhances the precision and efficiency of temperature control.

Simulation and Demonstration for the Thermoelectric Cooler to Improve Warm-up Time of OCXO

Temperature Sensing and Control to Improve Warm-up Time of OCXOs

FEA for Steady-State Thermal Performance of PCR Thermal-Cycler Based on Thermoelectric Cooler

Advancing Cryogenic Electronic Cooling: A Case Study on Embedded Manifold Microchannels in Micromachined Joule-Thomson Coolers

Design of Temperature Testing System in Multi-Parameter Combined Environmental Test

Numerical Simulation and Experimental Verification of Dynamic Cooling and Temperature Control of the Optical Cavity in a Co2 Isotope Analyzer

Numerical and Experimental Study of a Two-Phase Thermofluidic Oscillator with Regenerator Achieving Low Temperature-Differential Oscillation

Numerical Simulation On Ionic Wind Heat Transfer In A Thermoelectric Cooling Sysytem

How does Ambient Temperature Fluctuation Influence the Short-Term Frequency Stability of OCXO?

A Method to Increase the Frequency Stability of a TCXO by Compensating Thermal Hysteresis

Adaptive correction algorithm for high precision time maintenance of OCXO

Frequency Stabilization of an Optoelectronic Oscillator Based on Phase-Locked-Loop

A 0.1 ppm Successive Approximation Frequency-Temperature Compensation Method for Temperature Compensated Crystal Oscillators (TCXO)

A Digital-Analog Mixed Temperature Compensated Crystal Oscillator with 1.8v/0.18&#x03bc;m Mix-Signal CMOS Process

Design of the EEPROM Trimming Circuit for the Temperature Compensated Crystal Oscillator

Design of a New Analog TCXO with High Frequency Stability

Active suppression of temperature oscillation from a pulse-tube cryocooler in a cryogen-free cryostat: Part 1. Simulation modeling from thermal response characteristics

The Oven Controlled MEMS Oscillators in Timing and Sensing Applications: A review

Comparison between AMCXO and MCXO and necessity to develop AMCXO

Design of frequency calibration and test system for high-precision TCXO

A Transient Method for Testing Thermoelectric Coolers