Abstract:In this two part series (Zunker and Kamrin, 2024), we present a contact model able to capture the response of interacting adhesive elastic-perfectly plastic particles under a variety of loadings. In Part I, we focus on elastic through fully-plastic contact with and without adhesion. For these contact regimes the model is built upon the method of dimensionality reduction which allows the problem of a 3D axisymmetric contact to be mapped to a corresponding problem of a 1D rigid indenter penetrating a bed of independent Hookean springs. Plasticity is accounted for by continuously varying the 1D indenter profile subject to a constraint on the contact pressure. Unloading falls out naturally, and simply requires lifting the 1D indenter out of the springs and tracking the force. By accounting for the incompressible nature of this plastic deformation, the contact model is able to capture multi-neighbor dependent effects such as increased force and formation of new contacts. JKR type adhesion is recovered seamlessly within the method of dimensionality reduction by simply allowing the springs to ‘stick’ to the 1D indenter’s surface. Because of the mechanics-focused formulation of the contact model, only a few physical inputs describing the interacting particles are needed: particle radius, Young’s modulus, Poisson ratio, yield stress, and effective surface energy. The contact model is validated against finite element simulations and analytic theory—including Hertz’s contact law and the JKR theory of adhesion. These comparisons show that the proposed contact model is able to accurately capture plastic displacement, average contact pressure, contact area, and force as a function of displacement for contacts as well as particle volume within the elastic to fully-plastic regimes.

Dynamic Characteristics for the Normal Impact Process of Micro-Particles with a Flat Surface

A JKR-based dynamic model for the impact of micro-particle with a flat surface

Numerical simulations of the normal impact of adhesive microparticles with a rigid substrate

Normal impact of adhesive microparticles with a film/substrate system: A numerical study

Impact Crushing and Rebound of Thin-Walled Hollow Spheres

A numerical study on adhesive collision between a micro-sized particle and a wall

A mechanically-derived contact model for adhesive elastic-perfectly plastic particles. Part I: Utilizing the method of dimensionality reduction

A Finite Element Method (FEM) Study on Adhesive Particle-Wall Normal Collision

A Model for Computational Investigation of Elasto-Plastic Normal and Tangential Contact Considering Adhesion Effect

The normal restitution coefficient and critical sticking velocity of disk-shaped adhesive particles

A new impact dynamics model of a clearance joint considering the adhesive effects in space environment

A mechanically-derived contact model for adhesive elastic-perfectly plastic particles, Part I: Utilizing the method of dimensionality reduction

New Explicit Correlations for the Critical Sticking Velocity and Restitution Coefficient of Small Adhesive Particles: A Finite Element Study and Validation

The effect of surface roughness on normal restitution coefficient, adhesion force and friction coefficient of the particle-wall collision

Dynamic Behavior and Energy Absorption of Typical Porous Materials under Impacts

Α Model of Computation of Elastic and Plastic Contact Considering Adhesion Effect

A mechanically-derived contact model for adhesive elastic-perfectly plastic particles. Part II: Contact under high compaction--adding a bulk elastic response

Elasto-plastic and adhesive contact: an improved linear model and its application

The effect of incident angle on the rebound behavior of micro-particle impacts

A new discrete element method for small adhesive non-spherical particles

Transient Impact Response Analysis of an Elastic–plastic Beam