Abstract:The propagation of light from a singlemode fiber (SMF) to a multimode fiber (MMF) arouses a series of eigenmodes, which interference together along the MMF where the positions of the local maximum intensity are the self-imaging points (SIPS). When the light in the MMF propagates to a SMF, the maximum coupling efficiency is obtain when the SMF and MMF connect at a SIP. However the connection generally deviates the SIPs for the accurate connection is difficult to be achieved, which decreases the accuracy of the sensor severely. Herein a novel vibration sensor based on the singlemode multimode singlemode (SMS) fiber is developed, in which the MMF is etched, which turns the SIP to the connection of the MMF and the output SMF accurately. The etched SMS structure dispenses with the requirement of highly accurate connection at a SIP and provides a succedaneous scheme that is sensitive to vibration. The etched sensor responses to the vibration more easily comparing to the un-etched one. Experimental results demonstrate that the sensitivity of the SMS sensor with the both ends etched is respectively over 5 and 40 times as that of the middle etched and un-etched one. When the MMF length decreases from 8 to 2 cm, the vibrating sensitivity of the sensor increases 13.5 times. Experimental results demonstrate that the etched structure with MMF length of 2 cm responses well to the acoustic wave from 20 to 300 Hz, where a pressure sensitivity of 1.49 mV/mPa and linear correlation index of 0.9980 can be attained at 120 Hz. (C) 2018 Elsevier B.V. All rights reserved.

Vibration Sensor Based on the Resonance Power Leakage in a Tapered Capillary Fiber

Sub-Nanometer Acoustic Vibration Sensing Using a Tapered-Tip Optical Fiber Microcantilever

Femtosecond Laser Introduced Cantilever Beam on Optical Fiber for Vibration Sensing

Acoustic Vibration Sensor Based on Nonadiabatic Tapered Fibers

A Vibration Sensor Based on Fiber Bragg Grating Fabry-Perot Cavity

Vibration Sensor Based on Hollow Biconical Fiber

Acoustic Frequency Vibration Sensor Based on Tapered SMS Fiber Structure

Temperature-Insensitive Fiber Cantilever Vibration Sensor Based on A Fiber-To-Fiber Structure

Optical Displacement Sensor in A Capillary Covered Hollow Core Fiber Based on Anti-Resonant Reflecting Guidance

Vibration Sensor Based on Single Mode-Multimode Optic-Fiber Cantilever Structure

All-fiber Vibration Sensor Based on a Fabry–Perot Interferometer and a Microstructure Beam

Fiber-optic Micro Vibration Sensors Fabricated by a Femtosecond Laser

Non-contact Fiber Vibration Sensor based on Intracavity Modulation of an Extrinsic Fabry-Perot Interferometer

An Acoustic Sensor Based on Active Fiber Fabry-Pérot Microcavities

Load and Vibration Optical Fiber Sensor Based on Miniature Fabry–Perot Cavity Encapsulated by Micrometer Thickness of Silica Film

Design and Performance of Fiber Vibration Sensor Based on Fabry–Perot Structures with Microbubble

A dynamic spectral demodulation scheme of the fiber optical Fabry-Perot sensor for low-frequency vibration detection

Vibration Sensing Using a Tapered Bend-Insensitive Fiber Based Mach-Zehnder Interferometer

High-sensitivity sensor fabricated on the basis of single-mode fiber loop using frequency-sweeping-generated ringing effect

Broadband Vibration Detection in Tissue Phantoms Using a Fiber Fabry-Perot Cavity

Flexible Optical Fiber Fabry–Perot Interferometer Based Acoustic and Mechanical Vibration Sensor