Abstract:Non-equiatomic high entropy alloys (HEAs) and medium entropy alloys (MEAs) are expected to have the potential to exhibit good mechanical properties due to abundant composition designs compared to equiatomic alloys. It has been reported that an equiatomic CoCrNi MEA shows better strength-ductility balance than CoCrFeMnNi HEA, and there is a possibility that the mechanical properties can be further improved by changing chemical composition. Among the constituent elements, cobalt (Co) has the effect of decreasing stacking fault energy (SFE). In this study, we clarified the effect of Co-content on mechanical properties of non-equiatomic Co–Cr–Ni MEAs with different amounts of Co through investigating deformation behaviors and deformation microstructures. Cox(CrNi)(100−x) (x = 20 (Co20), 40 (Co40), 60 (Co60) at%) MEAs were processed to very high plastic strains by high-pressure torsion (HPT) and subsequently annealed under proper conditions to obtain FCC single-phase and uniform fine grain sizes. Mechanical properties of the specimens with fully recrystallized microstructures were characterized by tensile tests at room temperature. Their deformed microstructures at different tensile strain levels were observed by electron microscopy. The result of the tensile tests showed that the work-hardening rate was enhanced with increasing the Co-content although early fracture before reaching plastic instability condition occurred in Co60. Planar slip of dislocations and deformation twinning were observed in Co20 (SFE = 30 mJ/m2), while, in addition to them, deformation-induced martensitic transformation to HCP ε-martensite was observed in Co40 having lower SFE (SFE = 10 mJ/m2), leading to higher work-hardening rate. By increasing Co-content (decreasing SFE) further, phase fraction of ε-martensite greatly increased in Co60 (SFE = 0 mJ/m2) compared with Co40, and early fracture occurred due to stress concentration at intersects between martensite and grain boundaries. The present results suggested that the mechanical properties of the present materials could be effectively designed by controlling the SFE.

Effect of Co content on phase formation and mechanical properties of (AlCoCrFeNi) 100-x Co x high-entropy alloys

Effect of Co on phase stability and mechanical behavior of CoxCrFeNiMnAl0.3 high entropy alloys with micro/nano hierarchical structure

Microstructural Evolution and Elevated-Temperature Strengthening Mechanism of Co-free FeCrMnNiV0.2Alx High-Entropy Alloys During Annealing

First-principles calculation of phase transitions and mechanical properties of (CoCrNi)100−xAlx (0 ≤ x ≤ 28 at. %) high-entropy alloys

Microstructural Evolution and Mechanical Properties of Al0.3CoCrFeNiSix. High-Entropy Alloys Containing Coherent Nanometer-Scaled Precipitates

Effects of Al Addition on Microstructure and Mechanical Properties of Alxcocrfeni High-Entropy Alloy

Effect of Al Elements on the Microstructure and Properties of CoCrNiCuMoAlx High-Entropy Alloys

Effects of Al Addition on the Microstructure and Mechanical Property of AlxCoCrFeNi High-Entropy Alloys

Effect of Mo Content on Microstructure and Mechanical Properties of CoCrFeNi Series High-entropy Alloys

Formation of hypoeutectic structure and strengthening mechanism of Co4Cr1.5Fe1.5Ni5 high entropy alloy alloyed by Al

Effect of phase transformation of CoCrFeNiAl high-entropy alloy on mechanical properties of WC-CoCrFeNiAl composites

Impact of Cu Content on Microstructural Evolution and Mechanical Behavior of CoCrMo0.5TiVCux High-Entropy Alloys

Effect of Cobalt-Content on Mechanical Properties of Non-Equiatomic Co–Cr–Ni Medium Entropy Alloys

Effects of Elements on the Microstructure and Mechanical Properties of AlCoCrFeNiTi High-Entropy Alloys

Effect of Co Content on the Microstructure and Corrosion Behavior of Al0.3CoxCrFeNi High Entropy Alloys

Effects of Co/Ni ratio on microstructure and mechanical properties of as-cast Cr-Fe-Ni-Co-Al-Si-Ti-Cu high entropy alloys

Effect of Al content in CoCrFeNiAl x HEA on mechanical properties and high temperature oxidation resistance of WC-10%CoCrFeNiAl x hard alloy

Effect of Alloying on Microstructure and Mechanical Properties of AlCoCrFeNi2.1 Eutectic High-Entropy Alloy

The evolution of dual-phase core-shell structure and mechanical properties induced by Co addition in as-cast high-entropy intermetallic

Influence of V and Al in Enhancing the Strength and Ductility of Co-rich High-Entropy Alloys

Plasticity Improvement in a Co-Rich Co<sub>40</sub>Fe<sub>25</sub>Cr<sub>20</sub>Ni<sub>15</sub> High-Entropy Alloy via Al Alloying