Abstract:In a previous work, an ink based on a preceramic polymer, SiC fillers, and chopped carbon fibers was proposed for the production of Ceramic Matrix Composite (CMC) structures by Direct Ink Writing (DIW) and subsequent pyrolysis. Thanks to the shear stresses generated at the nozzle tip during extrusion, carbon fibers can be aligned along the printing direction. Fumed silica was added to the ink in order to enhance its rheological properties; however, the printed structures still showed some deformation in the Z direction. In this work, a second ink was successfully developed to limit deformation and at the same time avoid the addition of fumed silica, which limited the potential temperature of application of the composites. Instead, the positive role of the preceramic polymer on the ink rheology was exploited by increasing its concentration in the ink. Rheological characterization carried out on both inks confirmed that they possessed Bingham shear thinning behavior and fast viscosity recovery. Single filaments with different diameters (~310 µm and ~460 µm) were produced with the latter ink by DIW and subsequent pyrolysis. Tested under a four-point flexural test, the filaments showed a mean flexural strength above 30 MPa, graceful failure, and fiber pull-out. The results of this work suggest that CMC components can effectively be fabricated via DIW of a preceramic ink with embedded short fibers; the preceramic polymer is able to provide the desired rheology for the process and to develop a dense matrix capable of incorporating both fibers and ceramic particles, whereas the fibers addition contributes to an increase of the fracture toughness of the material and to the development of a graceful failure mode.

Preparation and Characterization of Neodymium Disilicate Ceramic Ink by Mechanical Grinding

Preparation and characterization of waterborne ceramic ink with submicron-sized praseodymium-doped zirconium silicate pigment by water-based diblock polymer dispersants

Preparation and characterization of ZnFe<sub>1.2</sub>Cr<sub>0.8</sub>O<sub>4</sub> water-based ceramic inks obtained using a polymeric dispersant

Development and Characterizations of Novel Aqueous-Based Ceramic Inks for Inkjet Printing

Study Of Dispersing Properties Of Silica Dioxide Used In Color Ink Jet Paper Coating

Preparation and optimization of silicon nitride slurries for digital light processing

Preparation and Parameters of Al2O3 Ceramic Ink by High-shear Dispersing Emulsifier

Rheological Behavior of Multi-Sized SiC Inks Containing Polyelectrolyte Complexes Specifically for Direct Ink Writing

Mechanical and Dielectric Properties of Direct Ink Writing Si2N2O Composites

A study on the dispersion properties of silicon dioxide in colour ink-jet printing paper

Preparation of Al2O3 Ceramic Jet Printing Ink by High-shear Dispersing Emulsifier

Study of Preparation and Property of BZN Ceramic Ink

Effect of Mechanical Activation on Solid-State Synthesis Process of Neodymium Disilicate Ceramic Pigment

Fabrication and properties of Si2N2O-Si3N4 ceramics via direct ink writing and low-temperature sintering

Preparation of Highly Dispersible Glass Frit Powders and Its Application in Ink-Jet Printing Ink

Effect of solid loading on properties of zirconia ceramic by direct ink writing

UV-assisted direct ink writing of Si3N4/SiC preceramic polymer suspensions

Optimization and Characterization of Preceramic Inks for Direct Ink Writing of Ceramic Matrix Composite Structures

Study of the Adsorption Performance and Preparation of Functional Nano-Silica Pigment Particles

Neodymium Disilicate Ceramic Pigment Synthesized by Solid-State Method with Pre-Grinding and Mineralizer