Abstract:Since power systems with a DC distribution method has many advantages, such as conversion efficiency increase of about 5–10%, cost reducing by about 15–20% and so on, the AC distribution power system will be replaced by a DC distribution one. This paper presents a DC load power system for a DC distribution application. The proposed power system includes two converters: DC/DC converter with battery source and power factor corrector (PFC) with a line source to increase the reliability of the power system when renewable energy or energy storage equipment are adopted. The proposed PFC adopts a bridgeless flyback converter to achieve power factor correction for supplying power to DC loads. When the bridgeless flyback converter is used to achieve PFC, it needs two transformers to process positive and negative half periods, respectively. In order to increase conversion efficiency, the flyback one can add two sets of the active clamp circuit to recover energies stored in leakage inductances of transformers in the converter. Therefore, the proposed bridgeless flyback converter can not only integrate two transformers into a single transformer, but also share a clamp capacitor to achieve energy recovery of leakage inductances and to operate switches with zero-voltage switching (ZVS) at the turn-on transition. With this approach, the proposed converter can increase conversion efficiency and decrease component counts, where it results in a higher conversion efficiency, lower cost, easier design and so on. Finally, a prototype with a universal input voltage source (AC 90–265 V) under output voltage of 48 V and maximum output power of 300 W has been implemented to verify the feasibility of the proposed bridgeless flyback converter. Furthermore, the proposed power system can be operated at different cases among load power PL, output power PDC1 of DC/DC converter and output power PDC2 of the proposed PFC for supplying power to DC loads.

Study of a Three-Phase Bridgeless Flyback PFC Converter

Study of a Single-stage Three-phase PFC DC/DC Converter With Series-parallel Connected Transforms

A high efficiency bridgeless flyback PFC converter for adapter application

Circuit Topology and Control of Three-Phase PFC Rectifier Bridge

Start-Up Scheme for A Three-Phase Isolated Full-Bridge Boost Pfc Converter with the Passive Flyback Auxiliary Circuit

Study and Design of a Novel Three-Phase Bridgeless Boost Power Factor Correction

The Modular-Combined Three-Phase Pfc Converter Based on Improved Full-Bridge Structure

Power Factor Corrector with Bridgeless Flyback Converter for DC Loads Applications

Investigation Of Key Technique For High Efficiency And High Power Density, Single-Stage Power Factor Correction Ac/Dc Converter

Single-Phase Bridgeless Three-Level Power Factor Correction Topologies Based on the Embedded Construction Scheme

Study on the Topologies of Single-stage Full-bridge Active PFC

Single-Phase Bridgeless PFC Topology Derivation and Performance Benchmarking

Three-phase Three-level PFC Rectifier Under Single-Cycle Control

High efficiency PFC with Enabling Window Control and active input bridge

Research on a Bridge Inverter Based Single-Stage PFC Topology and Control Stage

Three Phase PFC Converter with Multilevel Inductive Switching Network

High Power Factor Bridgeless Integrated Buck-Type PFC Converter With Wide Output Voltage Range

Single Stage PFC Circuit with Full Bridge Structure

Study of a New Single-phase PFC Method Based on One-cycle Control

Design and Implementation of Bridgeless Power Factor Corrector with Low Static Losses

Three-Phase Seven-level H-bridge Commutated Active Clamped Converter