Abstract:A one-dimensional model of the diesel engine working process was established, and thermal boundary conditions of gases contacting with a cylinder head were determined by comparing them with the results of a routine test. A fluid-structure interaction model between the cooling water and cylinder head passages was established in which boundary conditions of cooling water were obtained by computational fluid dynamics analysis. Simultaneously, considering the pressure mechanical load in the cylinder, temperature and the stress distribution of the cylinder head were analysed by the model with a thermo-mechanical coupling load. The model was validated using the temperature hardness plug method. Four parameters of intake valve opening, exhaust valve opening, fuel supply beginning, and compression ratio were selected as influencing factors, and the thermo-mechanical coupling load of the cylinder head was optimised by the Taguchi and analysis of variance method subsequently. The study indicates that the error of the calculation model for the cylinder head’s thermal-mechanical coupling load is within ±1.5%, and the proportion of the thermal stress in the cylinder head thermal-mechanical coupling stress is above 90%. The fuel supply beginning has the greatest influence on the thermal load of the cylinder head. Based on the optimisation methods within the required power range, the maximum temperature and maximum thermo-structural coupling stress of the cylinder head are decreased by about 10.05 K and 7.13 MPa in the nose bridge area, respectively.

A new coupling tribodynamic model of crosshead slipper-guide system and piston skirt-liner system of low-speed marine diesel engines

Impact of the Piston Secondary Motion on Its Slap Force

Transient tribo-dynamic analysis of crosshead slipper in low-speed marine diesel engines during engine startup

A new comprehensive tribo-dynamic analysis for lubricated translational joints in low-speed two-stroke marine engines

Crosshead Bearing Analysis For Low-Speed Marine Diesel Engines Based On A Multi-Body Tribo-Dynamic Model

Simulation Analysis and Experimental Verification of Tribodynamics of Reciprocating Friction Pairs in Low-Speed Marine Engines

Transient tribodynamic model of piston skirt-liner systems with variable speed effects

A new tribo-dynamics modeling and online measurement method for crosshead bearings in marine engines

A New Coupled Dynamic Model to Study the Vibration and Lubrication Characteristics of Slipper/Swash-Plate Interface in an Axial Piston Pump

Measurement of the friction force of sliding friction pairs in low-speed marine diesel engines and comparison with numerical simulation

A Piston Tribodynamic Model with Deterministic Consideration of Skirt Surface Grooves

Investigation of the lubrication performance of a marine diesel engine crankshaft using a thermo-electrohydrodynamic model

A fully coupled tribo-dynamic model for piston-ring-liner system

Coupling Simulation Between Tribology and Dynamic of Flexible Multi-Body of Piston Crankshaft System

A Numerical Simulation Of The Coupling Between Dynamic Behavior And Tribological Behavior In Cylinder-Piston System In Ic Engine

A New 3-D Multi-Physics Coupling Model for Lubricated Piston-Liner Systems

The Tribo-Dynamics Performance of the Lubricated Piston Skirt–Cylinder System Considering the Cylinder Liner Vibration

Tribological Simulation and Design of Piston Skirt- Liner System to Reduce Friction of Automotive Engines

Analysis and Optimisation of Thermo-Mechanical Coupling Load of Cylinder Head Considering Fluid-Structure Interaction for a Marine High-Power Diesel Engine

Tribo-dynamic Modeling Method and Application to Three-Dimensional Flexible PRL System

Study on coupling transient mixed lubrication and time-varying wear of main bearing in actual operation of low-speed diesel engine