Abstract:This paper presents a detailed investigation of the dry clutch engagement process, and vehicle start-up judder phenomenon that could result in the deterioration of vehicle ride comfort. Elasto-plastic friction model is elaborated through the slider-pulley system, which shows some friction characteristics such as presliding, stick-slip motion, Stribeck effects, etc., and applied to dry clutch. The axial compression characteristics of three elastic parts, which include diaphragm spring, cushion spring, and link strip have been taken into consideration, and nonlinear relationship between the release bearing travel and the clutch clamp force is also established. The powertrain system model of front-engine and front-wheel-drive vehicle equipped with manual transmission is set up to recreate the start-up judder phenomenon in the numerical simulation and analyze its mechanism. The sudden transfer of the engine torque during the clutch engagement process results in the initial judder, which can be supposed as the step response of system and is initially weakened due to the damping of the powertrain system. Then the judder gradually strengthens and gets in the most severe vibrance when the clutch is about to get in to the fully engaged state, which is related to the frictional characteristics that forms a closed-loop positive feedback system, as well as the frequent state transitions between sliding state and engaged state. The positive slope of Stribeck effect as well as the reduction of absolute value of negative slope can both effectively suppress the start-up judder, and the apparent judder occurs only if the negative slope is outside of a certain range, instead of in all of the range. In addition, the fluctuation of clutch clamp force can aggravate the start-up judder, in which a more chaotic oscillation is emerged.

Modeling and Experimental Validation of Lever-Based Electromechanical Actuator for Dry Clutches

Simultaneous Control of Motion and Maximized Stiffness for an Electro-Pneumatic Clutch Actuator Based on Pressure Observers

Analysis and Modeling for Electro-pneumatic AMT System

Simulation and Experiment on Dynamic Engagement Characteristics of Wet Clutch

Compound Sliding Mode Motion Trajectory Tracking Control of an Electro-Pneumatic Clutch Actuator While Maximizing Its Stiffness

Experimental and Theoretical Analysis of the Drag Torque in Wet Clutches

Globally Stable Pressure-Observer-Based Servo Control of an Electro-Pneumatic Clutch Actuator

Numerical and Experimental Research on Engagement Process of Wet Multi-Plate Friction Clutches with Groove Consideration

Analysis of Clutch Engagement Judder and Its Influence Factors

Simulation Research on the Drag Torque of Disengaged Wet Clutches

A Modified Predictive Functional Control with Sliding Mode Observer for Automated Dry Clutch Control of Vehicle

Engagement/Disengagement Characteristics of Pull-Type Diaphragm Spring Clutch for Heavy-Duty Commercial Vehicles

Modeling and control of ball-ramp electromechanical clutch actuator for in-wheel AMT of electric vehicles

Dynamic performance prediction and experimental analysis of wet clutch actuator considering thermal flow characteristics

Simulation Of Wet-Clutch Short-Time Load End Speed Control System On Amesim

Robust Output Feedback Controller with High-Gain Observer for Automatic Clutch

Hierarchical Control of Starting Process for Wet Dual Clutch Transmission Based on Direct-Drive Pump-Controlled Hydraulic Actuator

Design and Modeling of a Smart Torque-Adjustable Rotary Electroadhesive Clutch for Application in Human-Robot Interaction

Dynamic analysis of vehicle start-up judder based on elasto-plastic friction model and dry clutch maneuvering characteristic

Study on the Engagement Characteristics and Control Strategy of High Speed Difference Dry Friction Clutch

Analytical simulation of influential parameters affecting grooved wet clutches performance underdisengagement condition