Effect of ultrasonic shot peening on microstructure and properties of 301SS

Kejian Li,Gabriel Spartacus,Jiling Dong,Pengjun Cao,Keesam Shin

DOI: https://doi.org/10.1080/10426914.2017.1364863

IF: 4.7832

2017-01-01

Materials and Manufacturing Processes

Abstract:Ultrasonic shot peening (USP) is an efficient way to improve the mechanical behavior of 301 stainless steel by inducing severe plastic deformation on its surface. However, this surface treatment induces complex microstructural evolutions, such as grain refinement and phase transformation. Therefore, a better understanding of those evolution mechanisms is critical to optimize the USP treatment. In this work, we rely on various electron microscope observations to compare a specimen before and after a 5-min shot peening treatment. We found an affected layer of similar to 450 mu m with a significant increase in hardness on the top surface by a factor of 2.7 times. Inside this layer, we noticed a nanoscale grain layer of similar to 130 mu m, the most strengthened layer, containing nanoscale grain of , with few and a large amount of low angle grain boundaries on the topmost. Afterward, we observed coarse grains with deformation twins, which seem to be a preferential site for martensite nucleation, especially at their intersection, and a high density of dislocation. We also conducted experiments to determine a possible scenario for the microstructural evolution, based on those observations.