Abstract:<p>With the rapid development of manufacturing technology in the fields such as aerospace, aviation, national defense, and automobiles, the demands for lightweight, toughening, and forming accuracy of products have increased. As one of the main defects in the plastic forming of thin-walled components, wrinkling failure has always been a key element in forming control. The sheet metal is restrained by the mold in actual forming process and the wrinkling is significantly affected by the boundary conditions. To study the effect of the mold constraints on the wrinkling failure in the actual forming process, a stretching wrinkling test of wedge plate with the boundary constraint conditions of mold was designed. By establishing the simulation model for wrinkling failure of sheet forming under mold constraints and its wrinkling limit diagram (WLD), the accurate prediction of sheet metal wrinkling failure form and the critical state in actual forming was realized. At the beginning of the research, the wedge plate tensile test was implemented for using as verification for simulation results, then the wrinkle simulation model of Buckle-Dynamic with the instability mode as the initial defect was established. By combining with the non-contact full-field strain measurement system DIC to obtain the strain data of the specimens in the test process, the accuracy of the simulation model was verified. On this basis, the critical wrinkling limit diagram (WLD) was established for the wrinkle partition on the wedge specimen, and the influence of stress state, stress loading path, principal compressive stress increment, principal stress ratio factors on the distribution and propagation direction of wrinkles, as well as the morphology and characteristics of WLD are discussed. The research content of this study is of guiding significance for the prediction of the actual wrinkling failure of sheet and shell forming.</p>

Stress and Deformation Analysis on Hydro-forming Process of Ellipsoidal Shells with Double Generating Lines

Circumferential Folded Single-Layer Reticulated Spherical Shell and Simplified Calculation Method in Structure Static Analysis

Form of Circumferential Weld-Induced Imperfections for Tapered-Wall Cylindrical Shell Structures

Buckling Strength of Tapered Cylindrical Shells under Partial Axial Compression: Effect of Circumferential Weld-Induced Imperfections

Numerical Prediction and Control of Deformation and Residual Stress in Double-Sided Arc Welding of Large Pressure Hull

Effect of Post-Weld Heat Treatment on the Plastic Buckling of Welded Cylindrical Shells

Effect of Welding Residual Stress on Plastic Buckling of Axially Compressed Cylindrical Shells with Patterned Welds

Research Of Weld On Axial Buckling Stress Of Multilayer Combined Cylindrical Shells

Wrinkling of Toroidal Shells in Free Hydroforming

Analysis of Thickness Variation in 2219 Aluminum Alloy Ellipsoid Shell with Differential Thickness by Hydroforming

Analysis of the Stress around the Shell-to-bottom Fillet Welds of Large Oil Tanks

Numerical Simulation Analysis on Buckling Load of Large Combined Cylindrical Shells

Research on the establishment and influence mechanism of critical wrinkling limit diagram (WLD) of plate and shell forming under mold constraints

Deformation Patterns in Hydroforming of Thin-Walled Y-Shaped Tube

Effect of Weld on Axial Buckling of Cylindrical Shells

A New Design Method For Axially Loaded Thin-Walled Cylindrical Shells Based On Elasto-Plastic Buckling Analysis

Wrinkling Patterns in Soft Shells

Effect of Weld Reinforcement on Axial Plastic Buckling of Welded Steel Cylindrical Shells

Inhibiting plastic tensile instability of non-symmetric thin-walled shell component via increasing regional metal inflow based on heterogeneous pressure-carrying medium

Numerical investigation of controllable non-uniform deformation of tailor-welded blanks using heterogeneous pressure-carrying medium

Development of Experimental Method to Improve Sheet Metal Formability by Transverse Normal Stress