Abstract:Traditional dynamic method for temperature measurement is generally based on the assumption that the thermal inertia coefficient of a thermocouple junction is invariable (time constant) within the whole measuring process. Furthermore, the effect of heat conduction and heat radiation on the temperature response of the thermocouple is simply neglected under certain conditions. In this study, a new concept is proposed for improvement of the traditional dynamic method. The key point of the newly-proposed method is to tailor-make a thermocouple junction diameter to realize accurate compensation for radiation heat loss and specific heat capacity rising with the heat conduction from wires to the junction, which eventually makes the temperature response curve of the thermocouple still comply with the first-order response equation. The proposed method can be used for temperature measurement of high temperature flame, fine particle-laden flame as well as lab-scale small flame. Heat sink at the thermocouple junction due to heat conduction from neighboring wires to the junction is observed via numerical calculation, which can compensate the temperature rise lag of the junction caused by the radiation heat loss and the increase of specific heat capacity. Thus, there is no need to neglect the effect of heat conduction, heat radiation and thermal inertia coefficient variation on temperature measurement as in the traditional dynamic method. A thermocouple with the junction diameter of 0.7mm can retain relatively long time (ca. 2s) of steady apparent thermal inertia coefficient. The tailor-made thermocouple is applied to measure the temperature of TiO2 aerosol flame and sooting flame. The temperature measurement results agree well with both simulation results and benchmark experimental results, which indicates that the improved dynamic method and the tailor-made thermocouple can be employed to measure the temperature of fine particle-laden flame in a relatively straightforward manner.

Ito Thin Film Thermocouple For Transient High Temperature Measurement In Scramjet Combustor

ITO Thin Film Thermocouple for Dynamic Inner Wall Temperature Measurement of Supersonic Combustion

Experimental Study on Supersonic Combustion Fluctuation Using Thin-Film Thermocouple and Time–frequency Analysis

Temperature and heat flux measurement technologies in scramjet

Indium Tin Oxide Thin-Film Thermocouple Probe Based On Sapphire Microrod

Design and performance evaluation of an all-ceramic high-temperature test sensor

A Data Fusion Approach with High Spatiotemporal Resolution for Wall Temperature Measurement Upon Jet Impingement

High Sensitive Flexible Hot-Film Sensor for Measurement of Unsteady Boundary Layer Flow

Thin Film Thermocouples for Surface Temperature Measurement of Turbine Blade

A High Temporal-Spatial Resolution Temperature Sensor for Simultaneous Measurement of Anisotropic Heat Flow

Ito Thin Film Resistance Temperature Detector with Al/Al2O3 Protective Coating for High-Temperature Application

ITO Microstructures Regulation and Properties Based on Deposition Temperature

Fabrication and performances of high-temperature transient response ITO/In2O3 thin-film thermocouples

Research on a dedicated thin-film thermocouple testing system for transient temperature measurement

High temperature heat flux sensor with ITO/In2O3 thermopile for extreme environment sensing

Tailor-making Thermocouple Junction for Flame Temperature Measurement Via Dynamic Transient Method

On the Response of Coaxial Surface Thermocouples for Transient Aerodynamic Heating Measurements

Investigation on Transient Temperature of a Reciprocating Compressor Based on a Two-Thermocouple Probe

A Ceramic Heat Flux Sensor with High Sensitivity for Ultra High Temperature

Preparation and Thermoelectric Characteristics of ITO/PtRh:PtRh Thin Film Thermocouple

High Temperature Resistant Thin Film Thermocouple Prepared Based on Inkjet Printing