Abstract:Two dye sensitizers, methyl trans-3(2)-carboxy-8-deethyl-7-ethyl-8-oxo-pyropheophorbide-a (BChlorin-1) and methyl trans-3(2)-carboxy-7-demethyl-8-methyl-7-oxo-pyropheophorbide-a (BChlorin-2), with stable bacteriochlorin skeletons were synthesized and applied to dye-sensitized solar cells. Both sensitizers absorb the light all over the visible region owing to partial saturation of the two pyrrole rings on the Q(x) transition dipole. When they were deposited on a TiO2 film, the J-aggregates of the sensitizers are partially formed to give broad and red-shifted Q(y) bands. The surface coverage of TiO2 film by BChlorin-2 is much larger than by BChlorin-1, suggesting the former sensitizer forms more serious aggregation on the surface of TiO2, and this could cause more exciton annihilation to reduce the photocurrent of solar cell. The frontier molecular orbitals of both sensitizers obtained from the DFT calculations show no distinguishable difference. Extended calculations on the dye-TiO2Na model system suggest that additional LUMO + 2 orbital in BChlorin-1 may also contribute to the difference in photocurrent. The larger photovoltage in BChlorin-sensitized solar cell was attributed to a less efficient charge recombination in the dye-TiO2 interface to give a longer electron lifetime (tau). Additional 4-tert-butylpyridine in the electrolyte significantly reduced the photocurrent and the solar energy-to-electricity conversion efficiency (eta) of the solar cells, especially when BChlorin-2 was employed as a sensitizer. This dramatic decrease was attributed to the shift of conduction band edge (CBE) of TiO2 to a negative potential above the molecular Fermi level (MFL) of the sensitizers and suppressed the electron injection from the MFL of sensitizer to CBE of TiO2. Coadsorption of BChlorin-1 with chenodeoxycholic acid (CDCA) could break the dye aggregate and improve the incident photon-to-current conversion efficiency at the absorption bands maxima. BChlorin-1 sensitized solar cells coadsorbed with CDCA gave a longer electron lifetime and a larger diffusion coefficient than the cell without CDCA. By coadsorbing with 5 mM CDCA in solution, the BChlorin-1 sensitized solar cell gave a highest performance with short-circuit photocurrent = 18.4 mA cm(-2), open-circuit photovoltage = 0.54 V, fill factor = 0.66, and eta = 6.6% under the air mass AM 1.5 (100 mW cm(-2)) illumination.

Near-infrared Absorption Bacteriochlorophyll Derivatives As Biomaterial Electron Donor for Organic Solar Cells

Chlorophyll-based Organic Solar Cells with Improved Power Conversion Efficiency

Efficient Dye-Sensitized Solar Cell Based on Oxo-Bacteriochlorin Sensitizers with Broadband Absorption Capability

Dicyano-functionalized Chlorophyll Derivatives with Ambipolar Characteristic for Organic Photovoltaics

Organic Solar Cells Based on the Aggregate of Synthetic Chlorophyll Derivative with over 5% Efficiency

Heterojunction Organic Solar Cells with Efficient Charge Mobility and Separation Capabilities Studied by DFT

Biosupramolecular Bacteriochlorin Aggregates As Hole-Transporters for Perovskite Solar Cells

Enhancing the Performance of Polymer Solar Cells via Core Engineering of NIR-Absorbing Electron Acceptors.

Near-Infrared Nonfullerene Acceptors Based on Benzobis(thiazole) Unit for Efficient Organic Solar Cells with Low Energy Loss

Near-Infrared Electron Acceptors with Unfused Architecture for Efficient Organic Solar Cells.

Near infrared electron acceptors with a photoresponse beyond 1000 nm for highly efficient organic solar cells

Near-infrared absorbing non-fullerene acceptors with unfused D-A-D core for efficient organic solar cells

Solution processable low bandgap small molecule donors with naphthalene end-groups for organic solar cells

Rational molecular engineering towards efficient heterojunction solar cells based on organic molecular acceptor

Bacteriochlorin Aggregates As Dopant-Free Hole-Transporting Materials for Perovskite Solar Cells

Near-Infrared Electron Acceptors with Cyano-Substituted 2-(3-Oxo-2,3-dihydroinden-1-ylidene)malononitrile End-Groups for Organic Solar Cells

Conjugated Extension of Non-Fullerene Acceptors Enables Efficient Organic Solar Cells with Optoelectronic Response over 1000 nm

A novel chlorinated small molecule donor for efficient binary and ternary all-small-molecule organic solar cells

Exploration of the synergistic effect of chrysene-based core and benzothiophene acceptors on photovoltaic properties of organic solar cells

Novel V-shaped Naphthalene Diimide-Based Chromophores: First Theoretical Framework for Designing High Efficacy of Organic Solar Cells

Natural Bio‐additive Chlorophyll Derivative Enables 17.30% Efficiency Organic Solar Cells