Abstract:A novel donor–acceptor (D‐A) copolymer by incorporating 3,3′‐difluoro‐2,2′‐bithiophene is synthesized. Introducing 3,3′‐difluoro‐2,2′‐bithiophene unit introduces intramolecular F···S noncovalent interactions, which can enhance the planarity of the polymer chain, thereby improve molecular packing, crystallinity, and hole mobility. Finally, a photoelectric conversion efficiency (PCE) of 17.03% is achieved. This work can provide a new strategy for the design and synthesis of polymer donor materials. In this study, two novel donor–acceptor (D–A) copolymers are designed and synthesized, DTBT‐2T and DTBT‐2T2F with 2,2′‐bithiophene or 3,3′‐difluoro‐2,2′‐bithiophene as the donor unit and dithienobenzothiadiazole as the acceptor unit, and used them as donor materials in non‐fullerene organic solar cells (OSCs). Due to enhanced planarity of polymer chains resulted by the intramolecular F···S noncovalent interactions, the incorporation of 3,3′‐difluoro‐2,2′‐bithiophene unit instead of 2,2′‐bithiophene into the polymers can enhance their molecular packing, crystallinity and hole mobility. The DTBT‐2T:L8‐BO based binary OSCs deliver a power conversion efficiency (PCE) of only 9.71% with a Voc of 0.78 V, a Jsc of 20.69 mA cm−2, and an FF of 59.67%. Moreover, the introduction of fluoro atoms can lower the highest occupied molecular orbital levels. As a result, DTBT‐2T2F:L8‐BO based single‐junction binary OSCs exhibited less recombination loss, more balanced charge mobility, and more favorable morphology, resulting in an impressive PCE of 17.03% with a higher Voc of 0.89 V, a Jsc of 25.40 mA cm−2, and an FF of 75.74%. These results indicate that 3,3′‐difluoro‐2,2′‐bithiophene unit can be used as an effective building block to synthesize high performance polymer donor materials. This work greatly expands the selection range of donor units for constructing high‐performance polymers.

A novel chlorinated small molecule donor for efficient binary and ternary all-small-molecule organic solar cells

Oligomeric donor with appropriate crystallinity for organic solar cells

An Electron Acceptor With Broad Visible-Nir Absorption And Unique Solid State Packing For As-Cast High Performance Binary Organic Solar Cells

Dual-Accepting-Unit Design of Donor Material for All-Small-Molecule Organic Solar Cells with Efficiency Approaching 11%

The substituents on the intermediate electron-deficient groups in small molecular acceptors result appropriate morphologies for organic solar cells

A 3,3′‐Difluoro‐2,2′‐Bithiophene Based Donor Polymer Realizing High Efficiency (>17%) Single Junction Binary Organic Solar Cells

BDT-based donor polymer for organic solar cells to achieve high efficiency over 15% for ternary organic solar cells

Combining chlorination and sulfuration strategies for high-performance all-small-molecule organic solar cells

A nonfullerene acceptor incorporating a dithienopyran fused backbone for organic solar cells with efficiency over 14%

A rare case of brominated small molecule acceptors for high-efficiency organic solar cells

End Group Effect of Asymmetric Benzodithiophene‐Based Donor with Liquid‐Crystal State for Small‐Molecule Binary Solar Cell

Fully-unfused electron acceptors based on a steric boron dipyrromethene (BODIPY) core for organic solar cells

The Effect of Chlorination and Position Isomerization of Benzotriazole-based Acceptors on High-Voltage Organic Solar Cells based on Dithienobenzodithiophene (DTBDT)-Containing Polymer Donor

A Minimal Benzo[c][1,2,5]thiadiazole-Based Electron Acceptor As a Third Component Material for Ternary Polymer Solar Cells with Efficiencies Exceeding 16.0%

Asymmetric Liquid Crystalline Donors with Two Different End Groups Enable Efficient All-Small-molecule Organic Solar Cells

Chlorination Enabling a Low‐Cost Benzodithiophene‐Based Wide‐Bandgap Donor Polymer with an Efficiency of over 17%

18.9% Efficiency Ternary Organic Solar Cells Enabled by Isomerization Engineering of Chlorine‐Substitution on Small Molecule Donors

Benzo[c][1,2,5]thiadiazole-fused pentacyclic small molecule acceptors for organic solar cells

ITC‐2Cl: A Versatile Middle‐Bandgap Nonfullerene Acceptor for High‐Efficiency Panchromatic Ternary Organic Solar Cells

Chlorinated Carbon‐Bridged and Silicon‐Bridged Carbazole‐Based Nonfullerene Acceptors Manifest Synergistic Enhancement in Ternary Organic Solar Cell with Efficiency over 15%

Optimized energy level, morphology and photophysical procedure boosted the photovoltaic performance in monochlorinated benzothiadiazole-based polymer donors