Abstract:One of the factors significantly influencing the flow structures and vortices formed on delta wings is the shape of the leading edge. This study examined the impact of needle vortex generators, inspired by owl wings, on the flow characteristics over a slender delta wing with a sweep angle of 65° to improve its aerodynamic performance. These nature-inspired vortex generators were designed to apply no additional flow blockage or drag force. Flow visualization tests were conducted in a smoke tunnel to gain deeper insights into the effects of the vortex generators on the flow physics over the delta wing. The experiments were performed at three angles of attack of 10°, 15°, and 20° and a flow velocity of 2.6 m/s on two delta wings, with and without needle vortex generators at the leading edge and a Reynolds number of Re = 2.6 × . Flow visualization was conducted on six longitudinal sections, six transverse sections, one-floor surface section, and one leading edge section at three different angles of attack. In addition, the investigation involved assessing the vortex breakdown location and wake region. The formation of the vortices and the effects of the needle vortex generators on the temporal and instantaneous flow structures and vortices were also investigated. The results suggested that the use of the needle vortex generators along the leading edge of the delta wing made the vortices smaller and closer to the wing surface and wing axis, postponed the vortex breakdown by approximately 13% of the chord length, and decreased the fluctuations of vortex breakdown location. In addition, the use of needle vortex generators eliminated the secondary vortices.

Control of Flow Separation on Trailing Edge Flap Using a Delta-Shaped Vortex Generators

Research on the Effect of Vortex Generators on Controlling Flow Separation of Hydrofoil

Study On Vortex Generators For Control Of Attached Cavitation

Flow control on the NREL S809 wind turbine airfoil using vortex generators

Control Effect of Micro Vortex Generators on Leading Edge of Attached Cavitation

VORTEX CONTROL BY THE SPANWISE SUCTION FLOW ON THE UPPER SURFACE OF DELTA WING

Large Eddy Simulation Investigation of Micro-Vortex Generator Control Effect on Early Stage Sheet Cavitation

A flow separation control on cylinder flow

Numerical study of passive and active flow separation control over a NACA0012 airfoil

Separation Control Using Synthetic Vortex Generator Jets in Axial Compressor Cascade

Numerical study on technical and conceptual improvements to a civil aircraft trailing-edge flap using passive/active flow control

Control Effect of Micro Vortex Generators on Attached Cavitation Instability

Numerical Investigation of Leading Edge Flap on Cranked Arrow Wing

Modeling of Delta-Wing Type Vortex Generators

Hydrodynamic flow separation control through vortex generators

Introduction of a biomimetic device designed to improve the flow over a slender delta wing: visualization study

Simulation of Aerodynamic Performance Affected by Vortex Generators on Blunt Trailing-Edge Airfoils

Numerical-Simulation of Rolling Up of Leading Trailing-Edge Vortex Sheets for Slender Wings

Investigation of Practical Flow Control Methodologies with RANS/LES Hybrid Methods

Dynamic Mode Decomposition Analysis of Flow Separation Control on Wind Turbine Airfoil Using Leading−edge Rod

Unsteady Flow Control of a Plane Diffuser Based on a Karman-vortex Generator