Abstract:A thermoplastic vulcanizate (TPV) of a ethylene-propylene-diene terpolymer (EPDM) and nylon copolymer (PA) was prepared by dynamic vulcanization. Maleic anhydride (MAH)-grafted EPDM (EPDM-g-MAH), MAH-grafted EPR (EPR-g-MAH), and chlorinated polyethylene (CPE) were used as compatibilizers. The effect of dynamic vulcanization and compatibilizer on the crystallization behavior of PA was investigated. Differential scanning calorimeter measurement results showed no pronounced shift in the crystallization temperature for PA in EPDM-PA TPV compared to that for PA in the neat state, whereas the crystallization temperature increased after adding compatibilizer. The decrease in the crystallinity of TPVs was a result of the crystallization occurring in confined spaces between rubber particles. The equilibrium melting temperature (Tm-0) of the PA copolymer was measured and was determined to be 157degreesC. The isothermal crystallization kinetics of PA in the neat and TPV states also was investigated. The crystallization rate was highest in the compatibilized TPV and lowest in the neat PA, whereas it was intermediate in the uncompatibilized TPV unvulcanized blends. Compared with unvulcanized EPDM-PA blends, the dynamic vulcanization process seemed to cause an obvious increase in the crystallization rate of the PA copolymer, especially when a suitable compatibilizer was used. This occurred because the dynamic vulcanization introduced fine crosslinked rubber particles that could act as heterogeneous nucleating centers. In addition, the use of a suitable compatibilizer permitted the formation of finely dispersed vulcanized rubber particles and therefore increased the density of the nucleating centers. The complex morphology of the blends was investigated by atomic force microscopy to evaluate the effect of compatibilizer on the size of the dispersed rubber particles. Compared with the morphology of TPVs with the same dosage of EPDM-g-MAH compatibilizer, the morphology of TPVs using EPR-g-MAH as compatibilizer showed much smaller dispersed rubber particles, which may have contributed to the higher crystallization rate. (C) 2003 Wiley Periodicals, Inc.

Morphology and Non-Isothermal Crystallization of Dynamically Vulcanized PP/EPDM Blends in Situ Compatibilized Via Magnesium Dimethacrylate

PP/EPDM-based Dynamically Vulcanized Thermoplastic Olefin with Zinc Dimethacrylate: Preparation, Rheology, Morphology, Crystallization and Mechanical Properties

In Situ Reactive Compatibilization and Reinforcement of Peroxide Dynamically Vulcanized Polypropylene/ethylene‐propylene‐diene Monomer Tpv by Zinc Dimethacrylate

Morphology Study of Peroxide-Induced Dynamically Vulcanized Polypropylene/Ethylene-Propylene-Diene Monomer/Zinc Dimethacrylate Blends During Tensile Deformation

Structure and Properties of Peroxide Dynamically Vulcanized Polypropylene/Ethylene-Propylene-Diene/Zinc Dimethacrylate Composites

Magnesium Acrylate Induced Interfacial Compatibilization of EPDM/PP Thermoplastic Vulcanizate and Shape Memory Behavior

Effect of EPDM Content on Melt Flow, Microstructures and Fracture Behavior of Dynamically Vulcanized PP/EPDM Blends

Non-isothermal crystallization behavior of dynamically vulcanized long chain branched polypropylene/ethylene-propylene-diene monomer blends

Preparation and Properties of Peroxide Dynamically Vulcanized Polypropylene/ethylene‐propylene‐diene Monomer/zinc Dimethacrylate Thermoplastic Olefin

Investigation of crystallization behavior in dynamically vulcanized EPDM-nylon copolymer blends

Shape Memory Effect of Dynamically Vulcanized Ethylene-Propylene-diene Rubber/polypropylene Blends Realized by In-Situ Compatibilization of Sodium Methacrylate

Study on the microstructure and miscibility of dynamically vulcanized EPDM/PP blend by positron annihilation

Study of Dynamically Cured PP/MAH-g-EPDM/epoxy Blends

Dynamically photocrosslinking of polypropylene/EPDM blends as a thermoplastic elastomer

Mechanical properties, morphological structure, and thermal behavior of dynamically photocrosslinked PP/EPDM blends

Mechanical properties and structural characteristics of dynamically photocrosslinked PP/EPDM blends

Influence of Epoxidized Ethylene Propylene Diene Rubber on Nonisothermal Crystallization Kinetics and Mechanical Properties of Poly(butylene Terephthalate)/polypropylene Blend

A Study of the Crystallization Behaviour of Dynamically Vulcanized EPDM/Nylon Copolymer Blends

Effects of Compatibilizing Agent and in Situ Fibril on the Morphology, Interface and Mechanical Properties of EPDM/nylon Copolymer Blends

Polymerization Conversion and Structure of Magnesium Methacrylate in Ethylene–vinyl Acetate Rubber Vulcanizates

Morphology and Properties of PP/EPDM Binary Blends and PP/EPDM/nano‐CaCO3 Ternary Blends