Abstract:Tungsten fiber-reinforced tungsten composite (Wf/W) material is considered a plasma-facing material (PFM) with good application prospects. Commercial tungsten wire (fiber) prepared through forging and drawing processes has excellent mechanical properties, as well as a very high recrystallization temperature due to the unique texture of it grain structure. Commercial tungsten fiber is the most proper reinforcement for Wf/W. The change in the properties of tungsten fiber because of neutron irradiation makes it inevitable for Wf/W to be used as PFMs. However, there is very little research on the change in the properties of tungsten fiber caused by neutron irradiation. In this work, we used heavy ion irradiation to simulate the displacement damage generated by neutron irradiation to explore the alteration of the properties of a commercial tungsten fiber caused by neutron irradiation. The investigated subject was tungsten fiber with a diameter of 300 μm. The irradiation source was 7.5 MeV Au2+, which generated a maximum displacement damage of 60 dpa at a depth of 400 nm, and the irradiation influenced depth was 1000 nm. Because of the irradiation, significant lattice distortion occurred within the tungsten fiber, resulting in the transition from (110) texture to (100) texture at the fiber’s cross-section. The results of the Schmidt factor and Taylor factor analysis indicate a decrease in the plasticity of the tungsten fiber after irradiation, but it did not completely lose its plasticity. The results of the nanoindentation test confirmed the radiation hardening. After irradiation, the hardness of the tungsten fiber increased by approximately 0.33 GPa, but this increase was relatively small compared to other tungsten-based materials. This indicates that commercial tungsten fiber is a low-cost and highly reliable reinforcement material for Wf/W composite materials.

Irradiation Damage Behavior Research Status of Tungsten-matrix Materials Facing Plasma

Review of Irradiation Damage Behavior of Tungsten Exposed to Plasma in Nuclear Fusion

Progress in Irradiation Damage of Tungsten and Tungsten Alloys Under Different Irradiation Particles

The Microstructural and Hardness Changes of Tungsten Fiber after Au2+ Irradiation

Research Progress in Damage of Tungsten and Tungsten-base Materials for Nuclear Fusion Device

Nanostructure Evolution and Surface Modification of Tungsten Exposed to Low Energy, High Flux Deuterium Plasma

Recent Studies of Tungsten-Based Plasma-Facing Materials in the Linear Plasma Device STEP

Evolution of irradiation damage in tungsten matrix and Y 2 O 3 phase after low energy helium plasma exposure

Plasma and X-ray radiation-induced damage mechanisms in a tungsten heavy alloy

Deuterium Retention and Surface Blistering in Non-Damaged and Damaged Tungsten after Repetitive Plasma Exposure and Outgassing

Highly porous tungsten for plasma-facing applications in nuclear fusion power plants: a computational analysis of hollow nanoparticles

Neutron Irradiation-Induced Recrystallization Simulation for Tungsten in Nuclear Fusion Device

Experimental and simulation studies on damage mechanisms of tungsten and molybdenum under compressed plasma flow irradiation

MOLECULAR DYNAMICS SIMULATION OF INITIAL RADIATION DAMAGE IN TUNGSTEN

Effects of Low Energy and High Flux Helium/Hydrogen Plasma Irradiation on Tungsten As Plasma Facing Material

Development of irradiation tolerant tungsten alloys for high temperature nuclear applications

Comparison of Irradiation-Induced Void Formations in Tungsten with Equiaxed and Columnar Structures

The Microstructure and Radiation Resistance of Fine-Grained W-0.3 Wt%y2o3 Prepared by Nano In-Situ Composite Exposed to Low-Energy and High‑flux Helium Plasma

Research development of tungsten-based materials used as plasma facing materials of fusion reactor

The Evolution of Structural Defects under Irradiation in W by Molecular Dynamics Simulation

Thermal Damage of Tungsten-Armored Plasma-Facing Components under High Heat Flux Loads