Abstract:The accurate simulation of moisture transport in cement-based materials is an important step to predict many durability processes of concrete structures. This paper studied the effects of boundary conditions on modeling moisture transport, in particular for simulating drying kinetics and the inverse determination of liquid water permeability. Three boundary conditions were investigated, namely, the Dirichlet (imposed) condition, the flux boundary condition, and the boundary supplied by moisture movement in the ambient environment (coupling with a convection-diffusion moisture transport model). By comparing with the measured drying mass loss curves (without airflow) for ordinary Portland cement pastes, we found that the Dirichlet boundary condition provides slightly better simulated drying kinetics than the flux boundary condition, while results of the coupling model are less promising. As for inversely determined liquid permeability, the studied boundary conditions lead to the max. 36% difference. If considering the airflow in the environment, both the flux boundary condition and the coupling model with computational fluid dynamics (CFD) show that the airflow does not have an effect on moisture evaporation for the studied cement-based materials, because of their low permeability, resulting in a very short initial stage of drying. Moisture evaporation for these materials is mainly controlled by the internal moisture transport. However, for materials with high permeability, the drying kinetics increase with the airflow velocity because the initial stage of drying becomes much longer than the low permeable materials. The implication is that some laboratory methods for drying cement-based materials (specimens stored in a sealed chamber without airflow) may need to be reevaluated because the relative humidity at the material surface is different from the controlled relative humidity.

Test and Simulation on Moisture Flow in Earlyage Concrete under Drying

Theoretical Modeling and Verification of Concrete Moisture Diffusion Surface Factor

Moisture Movement in Early-Age Concrete under Cement Hydration and Environmental Drying

Simulation of moisture field of concrete with pre-soaked lightweight aggregate addition

A Mesoscale Three-Dimensional Moisture Transport Model in Concrete

Calculation of Moisture Distribution in Early-Age Concrete

Effect of Cementitious Permanent Formwork on Moisture Field of Internal-Cured Concrete under Drying

Numerical Analysis of Moisture Influential Depth in Concrete During Drying-Wetting Cycles

Numerical Analysis of Drying Shrinkage in Long Reinforced Concrete Structure

A Coupled Hygro-Thermal Model of Early-Age Concrete Based on Micro-Pore Structure Evolution

Influence of Pre-soaked Light-Weight Aggregate on Early-Age Interior Humidity Distribution and Development in Concrete Slab

MOISTURE CONDITIONS NEAR CONCRETE SURFACE: MODELLING AND APPROXIMATION

Interior Humidity of Concrete under Dry-Wet Cycles

Stability analysis of moisture influential depth in concrete under drying-wetting cycles

Determination of Moisture Diffusion Coefficient of Concrete at Early Age from Interior Humidity Measurements

Influential depth of moisture transport in concrete subject to drying–wetting cycles

Experimental Study on the Internal Relative Humidity in Concrete under Dry-Wet Cycles

Effects of model boundary conditions on simulated drying kinetics and inversely determined liquid water permeability for cement-based materials

Numerical Analysis of Moisture Influential Depth in Concrete and Its Application in Durability Design

Influence of Flexural Loading on Chloride Ingress in Concrete Subjected to Cyclic Drying-Wetting Condition

Effect of Moisture Content and Porosity on Compressive Strength of Concrete During Drying at 105 °C