Facile Synthesis of PtxNiy Catalyst Supported on Carbon for Low Temperature H2–SCR

Bao-sheng Tu,Wei Sun,Yi-jun Xue,Waqas Qamar Zaman,Li-mei Cao,Ji Yang
DOI: https://doi.org/10.1021/acssuschemeng.7b00540
IF: 8.4
2017-01-01
ACS Sustainable Chemistry & Engineering
Abstract:PtNi alloy nanoparticles supported on carbon (XC-72) are synthesized via a one-pot synthetic approach. This synthesized bimetallic composite offers several advantages, such as reduction of precious Pt along with an increase in activity due to the modified electronic structure. The prepared PtNi/C catalysts were employed as catalysts for NO removal both in a fixed-bed reactor and in a newly designed gas diffusion reactor. The performances of all prepared PtNi/C catalysts were higher than Pt/C at the same conditions and maintained a stable NO removal at a wide temperature window (100-300 degrees C), especially for Pt65Ni35 (more than 95% from 120 to 300 degrees C). This is attractive for low temperature SCR technology. According to XPS analysis, the surface layer phase was comprised of Pt contents with Ni being localized beneath the successive layers until Ni content increased to 67% mole ratio. The surface presence of Ni significantly affects the Pt electronic structure and raises the mass specific activity of Pt. Meanwhile, PtNi/C catalysts were introduced in a new gas diffusion reactor to remove NO under quantitatively less catalysts (30 mg), high NO concentration (1000 ppm), and at a high flow rate (resulting in a very short residence time of 0.09 s) condition. NO removal reaches almost 100% below 95 degrees C for all the PtNi catalysts and among all Pt65Ni35 exhibited the best performance. In addition, the influence of SO2 on the performance of Pt65Ni35 was also investigated, and the catalysts exposed a good antipoisonous property. The excellent performance of PtNi catalysts and a gas diffusion reactor are strongly recommended for their utilization as highly active and economical technology for NO removal.
What problem does this paper attempt to address?