Abstract:In this paper, a highly sensitive paper-based humidity sensor is designed and fabricated to overcome the typically low sensitivity and small quality factor of paper-based chipless radio-frequency identification (RFID) humidity sensors. A toroidal inductor-interdigitated electrodes (IDE) capacitor is used as the resonator structure of the new sensor, and the structural parameters of the sensor are optimized using the software of high frequency structure simulator (HFSS) to improve the quality factor. Three paper-based sensor samples were fabricated via screen printing using regular printing paper, Kodak photo paper, and double-sided copper-coated paper as the substrate. In addition, the resonance characteristics, sensitivity, recovery characteristics, stability and other sensor performances were tested. The results show that the sensitivity of the copper-coated-paper-based sensor is significantly better than the two other paper-based sensors. The simulation and test results of the moisture-sensitive characteristics are consistent for graphene oxide (GO) films, which were prepared using the spray method on the surface of the copper-coated-paper-based sensor with mass concentrations of 1 mg/mL, 2 mg/mL, and 5 mg/mL. This indicates that GO films can significantly improve sensor sensitivity when combined with paper-based moisture sensing. Furthermore, the sensitivity increases with increasing GO concentration, the 5 mg/mL GO sensor show a sensitivity of 6.25 MHz/%RH and a range of 60% RH-90% RH. The 1 mg/mL GO humidity sensor shows good recovery characteristics (92.4% recovery). Based on the presence of hydrophilic functional groups in the GO material, a moisture sensing mechanism that GO could improve the sensitivity of the sensor is analyzed.

A Film Bulk Acoustic Resonator Oscillator Based Humidity Sensor with Graphene Oxide As the Sensitive Layer

Fiber Optic Relative Humidity Sensor Based On The Tilted Fiber Bragg Grating Coated With Graphene Oxide

Flexible Humidity Sensors with High Water-Resistance Based on a Composite of Sodium Carboxymethyl Cellulose, Graphene Oxide and 3-Glycidyloxypropyl Trimethoxysilane

A Humidity Sensor Based on Lamb Wave Resonator with Different Graphene Oxide Film

Graphene oxide decorated multi-frequency surface acoustic wave humidity sensor for hygienic applications

A Humidity Sensor Based on AlN Lamb Wave Resonator Coated with Graphene Oxide of Different Concentrations

Chemically Sensitized Thin-Film Bulk Acoustic Wave Resonators As Humidity Sensors

Humidity sensor based on core-offset fiber Mach-Zehnder interferometer coated graphene oxide film

A highly sensitive paper-based chipless RFID humidity sensor based on graphene oxide

A Miniaturized Integrated SAW Sensing System for Relative Humidity Based on Graphene Oxide Film

An Aln Two-Dimensional Acoustic Wave Humidity Sensor With Graphene Oxide As Sensing Layer

High performance graphene oxide-based humidity sensor integrated on a photonic crystal cavity

Humidity Sensor Composed of Laser-Induced Graphene Electrode and Graphene Oxide for Monitoring Respiration and Skin Moisture

Specific Sensing Mechanism Investigation of Surface Acoustic Wave Humidity Sensors Coated with Uniform Graphene Oxide Membrane

A HUMIDITY SENSOR WITH HIGH SENSITIVITY AND LOW TEMPERATURE COEFFICIENT OF FREQUENCY BASED ON ALN SURFACE ACOUSTIC WAVE AND GRAPHENE OXIDE SENSING LAYER

A Serial Flexible Humidity Sensor Based on Graphene Oxide Fibers and Quartz Crystal Resonator

Highly Sensitive AIN Surface Acoustic Wave Humidity Sensor Based on Uniform Graphene Oxide Thin Film Formed by Surface Tension

Humidity Sensor With Graphene Oxide As Sensing Material

A High Performance Humidity Sensor Based on Surface Acoustic Wave and Graphene Oxide on AlN/Si Layered Structure

Polyelectrolyte/Graphene Oxide Nano-Film Integrated Fiber-Optic Sensors for High-Sensitive and Rapid-Response Humidity Measurement

Surface acoustic wave humidity sensors based on uniform and thickness controllable graphene oxide thin films formed by surface tension