Abstract:s With the restriction on the use of high-GWP refrigerants in the international community, research on environmentally friendly refrigerant mixtures and reducing the use of refrigerants have gradually become important topics in academia. Therefore, in this study, the low-GWP zeotropic mixtures are selected as the target refrigerants and combined with falling film evaporation heat transfer technology that can reduce the refrigerant charge, to conduct the falling film evaporation heat transfer in the refrigeration system. The experimental refrigerants are R134a, R32, R32/R134a (0.5, 0.5), and R32/R1234ze(E) (0.5,0.5). And two wettable surfaces are prepared by oxidative etching. The effects of oil content ( ω ), spray density ( Γ ), heat flux ( q ), evaporation temperature ( T e ), and surface wettability on heat transfer coefficient ( HTC ) are investigated. The experimental operation conditions are as follows: ω of 1.82 ∼ 6.32 %, Γ of 0.0049 ∼ 0.0194 kg/(m·s), q of 10 ∼ 45 kW/m 2 , and T e of 3 ∼ 9 °C. The study found that when ω is relatively low, an increase in ω has a weak impact on HTC , potentially resulting in a slight increase or decrease in HTC . However, when ω is greater than 3 %, increasing ω can significantly reduce HTC , with a reduction of up to 50 %. An increase in q increases the effect of oil on heat transfer deterioration. Besides, the increase of ω delays the appearance of critical heat flux ( CHF ). HTC of R32/R134a is about 1 ∼ 1.25 times that of R32/R1234ze(E). HTC of R134a is approximately 1 ∼ 1.1 times that of R32/R134a, which indicates that the mass transfer resistance of zeotropic refrigerant reduces its heat transfer performance. The difference of HTC s between R134a and R32/R134a becomes larger as q rises. Although the difference in contact angle of refrigerant on surfaces with different wettability is small, the resulting difference in heat transfer performance is very significant. Compared to plain tube, oxidative etching tube can enhance HTC by approximately 25 %. However, increasing surface wettability can lead to an early onset of dry spots and the emergence of CHF . Increasing Γ can increase CHF and delay the onset of CHF . This study provides a very meaningful attempt for the application of low-GWP zeotropic refrigerant in falling film evaporation refrigeration system, and provides important experimental data for improving HTC of falling film evaporation.

Experimental Study on LiCl Solution Falling-Film Generation Process Outside a Vertical Tube

Effect of falling-film generation outside vertical tube with lithium chloride aqueous solution

Experimental study on heat and mass transfer performance of falling film absorption over a vertical tube using LiCl solution

Design and Experimental Study of A Plate-Type Falling-Film Generator for A Libr/H2o Absorption Heat Pump

Experimental Study on Heat and Mass Transfer in Falling Film Absorption of Aqueous Lithium Chloride.

Experimental Research on the Vapor Pressures of CaCl2–H2O and MgCl2–H2O As Working Fluids of Absorption Heat Transformers at High Temperature

Hybrid Heat Transfer with Falling Film and Pool Boiling Using R-134a Outside a Vertical Tube

Experimental study of double direct contact ice slurry generator

Experimental investigation on enhancing technology of falling film absorption for LiBr aqueous solution

Experimental Research on the Performance of a Gas Lift Bubble Pump Based on a Diffusion Generation Process

Experimental study on falling film evaporation heat transfer outside a horizontal tube in refrigeration system

Experimental and Numerical Study on the Regeneration Performance of LiCl Solution with Surfactant and Nanoparticles

Experimental Study On Enhanced Falling Film Absorption Process Using H2o/Libr Nanofluids

Experimental Study on the High Temperature Vertical Tube Falling Film Absorption Process of LiBr Solution

Experimental Research on Spray Type Generator of LiBr Refrigerator driven by hot Water

A novel low-grade heat-driven absorption refrigeration system with LiCl–H2O and LiBr–H2O working pairs

Experimental Investigations of R134a and R123 Falling Film Evaporation on Enhanced Horizontal Tubes.

Experimental Study of Falling-Film Mode Transitions Between Horizontal Tubes in CaCl2/water Absorber

Investigation of Falling-Film Plate Wettability Characteristics under Dehumidification and Regeneration Conditions Using LiCl-H2O

Investigation on Mass Transfer Characteristics of the Falling Film Absorption of LiBr Aqueous Solution Added with Nanoparticles

Experimental Study of Thermo-siphon Generator for Solar Energy LiBr Absorption Refrigerator