Abstract:A simulation model using the first thermodynamic law is first proposed to estimate the performance of diffusion absorption heat transformer, which could potentially improve energy utilization efficiency and reduce CO2 emission. Thermodynamic analyses are performed to investigate the cycle performance when H2O is employed as refrigerant, LiBr as absorbent for H2O, R134a as diffusion gas and TEGDME as absorbent for R134a. Analyses aim to optimize system COP under specified temperature of two generators, two absorbers, evaporator and condenser, and compare the influence of the six temperatures on COP. The results under design conditions show that larger generation efficiency of R134a and smaller mass fraction of LiBr in H2O–LiBr solution are beneficial to COP improvement, but they are limited by the operating conditions. There is an optimal ratio of H2O–LiBr solution mass flow rate to R134a mass flow rate for an optimal COP, and the optimal ratio decreases with the increase of LiBr mass fraction in H2O–LiBr solution. The highest COP of 0.1701 is reached with the optimal ratio of 1.743. In addition, under design-off conditions, the temperatures of refrigerant generator and evaporator have the greatest influence on COP while the temperature of diffusion gas generator has the least influence. The diffusion absorption heat transformer will provide a new way to lift temperature of low grade heat without electricity input which can further improve the energy utilization efficiency and reduce the CO2 emission.

A novel low-grade heat-driven absorption refrigeration system with LiCl–H2O and LiBr–H2O working pairs

Theoretical Analyses of a New Two-Stage Absorption-Transcritical Hybrid Refrigeration System

Analysis of a Hybrid System of Adiabatic Absorption two-stage Liquid Desiccant and CO2 Transcritical Cycles

Utilization of Ultra-Low Temperature Heat by a Novel Cascade Refrigeration System with Environmentally-Friendly Refrigerants

Vapor–liquid Equilibria of HFC‐161 + HFC‐32 + DMF Ternary Mixture for Low‐grade Heat Driven Absorption Refrigeration System

Analysis of a Hybrid System of Liquid Desiccant and CO2 Transcritical Cycles

Study on the Performance of a Novel Waste Heat Recovery System at Low Temperatures

A NOVEL COMBINED EJECTOR-ABSORPTION REFRIGERATION CYCLE

Experimental Study on an Absorption Refrigeration System at Low Temperatures

Investigations on Performance of an Auto-Cascade Absorption Refrigeration System Operating with Mixed Refrigerants

Optimization Analyses on the Performance of an Auto-Cascade Absorption Refrigeration System Operating with Mixed Refrigerants

Theoretical Investigations on the Cycle Performance of a Single-Pressure Diffusion Absorption Heat Transformer with LiBr–H2O-R134a-TEGDME

Experimental Study of a New Ejector-Absorption Refrigeration Cycle Driven by Multi-Heat Sources

Thermodynamic Performance of a Double-Effect Absorption Refrigeration Cycle Based on a Ternary Working Pair: Lithium Bromide + Ionic Liquids + Water

Study on CaCl2-LiCl/H2O As Working Pair of Absorption Refrigeration Cycle

Theoretical Study of Dual-Heat Mode Operation of Double-Effect Parallel-Flow LiBr-H_2O Absorption Refrigeration System

A novel variable effect LiBr-water absorption refrigeration cycle

Performance Comparison of Two Absorption-Compression Hybrid Refrigeration Systems Using R1234yf/ionic Liquid As Working Pair

Multi-mode Integrated System of Adsorption Refrigeration Using Desiccant Coated Heat Exchangers for Ultra-Low Grade Heat Utilization

Study on a Quaternary Working Pair of CaCl2-LiNO3-KNO3/H2O for an Absorption Refrigeration Cycle

Absorption refrigeration cycle utilizing a new working pair of ionic liquid type