Abstract:The use of microwaves for heating is well established in society, and is being used in domestic and some industrial processes. However, it has the potential to be introduced and applied to many other industrial heating processes, which offers unique advantages not attained from conventional heating. In this sense, microwave technology was being explored as one method to assist in pyrolysis process of cotton stalk. A study was carried out on the effect of microwave on the liquid and solid products, then the physicochemical properties of pyrolysis products were analyzed by gas chromatography and mass spectrometry (GC-MS), isothermal adsorption analyzer (BET) and fourier transform infrared analyzer (FT-IR). The results showed that with the rising of the pyrolysis temperature, the yields of gas and liquid products had shown opposite trend, and the highest yield of bio-oil was around 500℃ (about 40%), however, the yield of char gradually decreased. Furthermore, within 550-650℃ the changing rate became weaker. The bio-oil had a complex composition, and major compounds in the liquid product were acetic acid, levoglucosan and phenolic substances. Besides the content of decreased acetic acid and levoglucosan with the increasing temperature, while acetic acid obtained by microwave heating was significantly lower comparing with conventional electric heating, which made the acidity of liquid products decrease, the high content of levoglucosan in the cotton stalk oil was discovered under microwave heating, which could go up to 19.86%. In addition, phenolic substances went up with the increasing temperature when below 450℃then multi-substituted phenolic substances had been declined but the content of phenol and hydroquinone increased when above 450℃, so it changed little in total phenolics. Conventionally pyrolysed char could not be used for further application since there persisted large and deep cracks due to the overheating of surfaces, which made them fragile and lost porous nature. Analysis of the product showed the adsorption loop type was L3. Moreover, microwave heating technique was conducive to the formation of the developed pore structure and the specific surface area and micro-pore surface area were first increased and then decreased as the temperature rose, the maximum of SBET and Smic reached 400.29 m2/g and 276.93 m2/g at 550℃, which was known as microwave heating and was highly effective in pyrolysing biomass, specifically the large size which otherwise if not possible but would had been difficult. The surface functional groups of char at 350℃ mainly included O-H (3 500-3 000 cm-1), C-Hn(2 970-2 860 cm-1), C=O(1 730-1 700 cm-1), C=C(1 632 cm-1), C-O-C(1 260 cm-1) and C-H(900-700 cm-1), then gradually decreased as temperature increased. Only small amount of aromatic structure peak (around 1 450-1 600 cm-1) could be detected at 650℃, which indicated the char had been close to completely pyrolysis. The comparative results showed that microwave pyrolysis had a very good prospect on the optimization of bio-oil, getting high value-added products such as levoglucosan, and also the preparation of activated char with high specific surface area.

Controllable production of liquid and solid biofuels by doping-free, microwave-assisted, pressurised pyrolysis of hemicellulose

Hydrothermal Carbonization of Cellulose and Xylan into Hydrochars and Application on Glucose Isomerization

The preparation of high-grade bio-oils through the controlled, low temperature microwave activation of wheat straw

Low temperature microwave irradiation as an activator of biomass pyrolysis

The potential of microwave technology for the recovery, synthesis and manufacturing of chemicals from bio-wastes

Microwave assisted decomposition of cellulose: A new thermochemical route for biomass exploitation

Property Analysis of Pyrolysis Product from Cotton Stalk Heating by Microwave

The Microwave Pyrolysis of Biomass

CO2 Gasification of Bio-Char Derived from Conventional and Microwave Pyrolysis

Production of Hydrocarbons from Biomass-Derived Biochar Assisted Microwave Catalytic Pyrolysis

Sugarcane Bagasse Pyrolysis in a Carbon Dioxide Atmosphere with Conventional and Microwave-Assisted Heating

Production of H2-Rich Syngas From Lignocellulosic Biomass Using Microwave-Assisted Pyrolysis Coupled With Activated Carbon Enabled Reforming

CO 2 gasification of biochar derived from conventional and 1 microwave pyrolysis 2

Microwave-assisted Pyrolysis of Microalgae for Biofuel Production.

Porous Biochar Production from Microwave-Assisted Pyrolysis of Biomass

Biofuel Production from Distillers Dried Grains with Solubles (DDGS) Co-Fed with Waste Agricultural Plastic Mulching Films Via Microwave-Assisted Catalytic Fast Pyrolysis Using Microwave Absorbent and Hierarchical ZSM-5/MCM-41 Catalyst

Progress in microwave pyrolysis conversion of agricultural waste to value-added biofuels: A batch to continuous approach

Microwave pyrolysis coupled with conventional pre-pyrolysis of the stalk for syngas and biochar

Catalytic co-pyrolysis of solid wastes (low-density polyethylene and lignocellulosic biomass) over microwave assisted biochar for bio-oil upgrading and hydrogen production

Simultaneous implementation of sludge dewatering and solid biofuel production by microwave torrefaction

Microwave-assisted catalytic upgrading of co-pyrolysis vapor using HZSM-5 and MCM-41 for bio-oil production: Co-feeding of soapstock and straw in a downdraft reactor