Abstract:Al–Li alloy has a wide range of application prospects in aerospace and rail transportation fields. Friction stir welding (FSW) is suitable for joining of Al–Li alloy. The microstructure evolution in FSW of Al–Li alloy determines the final joint properties. However, it is difficult to directly observe the microstructure evolution in FSW of Al–Li alloy only by experimental methods. Therefore, a Monte Carlo model in cooperation with a thermomechanical finite element model was proposed to study the microstructure evolution in FSW of 2195 Al–Li alloy. The validated thermomechanical finite element model was first used to calculate the temperature field, strain rate and strain evolution during the FSW process. Then, the achieved thermomechanical history was used in the Monte Carlo model to predict the transient microstructure evolution and the final morphology of the grain structure. It is found that the plastic materials on the advancing side experience a higher strain compared with that on the retreating side with the same distance from the joint line. The plastic material in the middle of the weld nugget zone (WNZ) experiences a relatively high temperature with more severe plastic deformation. Therefore, fully dynamic recrystallization takes place for the material at this region as it flows across the tool during FSW, which results in a fine recrystallization grain in the middle of WNZ. However, the material on the advancing side at 2 mm away from the joint line experiences a lower strain rate, which results in partial recrystallization with some relatively large grains of the base materials. The simulated average grain size and grain morphology were in good agreement with the measured results by EBSD method.

Precipitation-Induced Grain Growth Simulation of Friction-Stir-Welded AA6082-T6

Atypical Grain Coarsening of Friction Stir Welded AA6082-T6: Characterization and Modeling

Experimental and numerical studies of relationship between microstructures and mechanical properties in friction stir welding under water

The Mechanism of Grain Coarsening in Friction-Stir-Welded AA5083 after Heat Treatment

Inhibition of Abnormal Grain Growth in Stir Zone Via In-Situ Intermetallic Particle Formation During Friction Stir Welding of AA6061

Analysis and characterization of dynamic recrystallization and grain structure evolution in friction stir welding of aluminum plates

Precipitate Evolution in Friction Stir Welding of 2219-T6 Aluminum Alloys

Evaluation of Dynamic Recrystallization Phenomenon in Friction Stir Welding of AA5083-O by Cellular Automata Finite Element Approach

Multi-scale modelling of the microstructure evolution during friction stir welding of 2195 Al–Li alloy

Three-dimensional Monte Carlo simulation of discontinuous grain growth in HAZ of stainless steel during GTAW process

Entire Process Simulation of Friction Stir Welding — Part 1: Experiments and Simulation

Integrated modeling of microstructure-property-distortion relationship in friction stir additive manufacturing

The simulation of microstructural evolutions in friction stir additive manufacturing

Role of ultrasonic in synergistic strengthening of friction stir welded alloys by grain refinement and rapid nanoscale precipitation

Evolution of Strengthening Precipitates During Friction Stir Welding of Al-Zn and Al-Cu Alloys

Crystal Plasticity Modeling for Mechanical Property Prediction of AA2195-T6 Friction Stir Welded Joints

Numerical simulation and experimental investigation on friction stir welding of 6061-T6 aluminum alloy

Simulation of Material Flow Behavior during Friction Stir Welding of 7075 Aluminum Alloy

Parametric effect on microstructure evolution, grain size and mechanical behaviour of friction stir butt welding of AA6061-T6 alloy

Simulation of Friction Stir Welding of AZ31 Mg Alloys

Three Dimensional Monte Carlo Simulation of Grain Growth in HAZ of Stainless Steel SUS316