A Numerical and Experimental Analysis of Microstructural Aspects in AA2024-T3 Friction Stir Welding
Pierpaolo Carlone,Gaetano S. Palazzo
DOI: https://doi.org/10.4028/www.scientific.net/kem.554-557.1022
2013-06-01
Key Engineering Materials
Abstract:In recent years, remarkable interest has been focused on the Friction Stir Welding (FSW) process, by academic as well as industrial research groups. Conceptually, the FSW process is quite simple: a non-consumable rotating tool is plunged between the adjoining edges of the parts to be welded and moved along the desired weld line. Frictional and viscous heat generation increases the work piece temperature, softening the processing material and forcing it to flow around the pin. Although FSW has been effectively applied in welding of several materials, such as copper, steel, magnesium, and titanium, considerable attention is still focused on aluminum welding, in particular for transport applications. Recent literature clearly evidenced microstructural variations in the stir zone, imputable to continuous dynamic recrystallization phenomena, leading to the formation of a finer equiaxed grains. Moreover, depending on the specific alloy, thermal cycles can induce coarsening or dissolution of precipitates in the thermo-mechanically affected zone (TMAZ) and in the heat affected zone (HAZ). The influence of the aforementioned microstructural aspects on mechanical properties and formability of FSWed assemblies is also well recognized. The aim of this paper is to numerically and experimentally investigate the influence of process parameters, namely rotating speed and welding speed, on microstructural aspects in AA2024-T3 friction stir butt welds. A three-dimensional Computational Fluid Dynamic (CFD) model has been implemented to simulate the process. A viscoplastic material model, based on Wright and Sheppard modification of the constitutive model initially proposed by Sellars and Tegart has been implemented in the commercial package ANSYS CFX, considering an Eulerian framework. Tool-workpiece interaction has been modeled assuming partial sticking/sliding condition, and incorporating both frictional and viscous contributions to the heat generation. Microstructural aspects have been numerically predicted using the Zenner-Holloman parameter and experimentally measured by means of conventional metallographic techniques. Satisfactory agreement has been found between simulated and experimental results. The influence of process parameters on mechanical properties has also been highlighted.
English Else