Abstract:Based on genetic aggregation response surface models and multi-objective genetic algorithms, the effects of key structural parameters and inlet velocities on the shell-side flow and heat transfer of rod-baffle heat exchangers (RBHXs) with twisted oval tubes were investigated. The performance of twisted-oval-tube RBHXs was optimized. The results show that the heat transfer coefficient h decreases by 9.38% firstly and then remains constant with the increase of the pitch and it increases with the ratio of long axis to short axis under lower inlet velocities and decreases firstly and then increases when inlet velocities are higher. When the inlet velocity is 0.1 m/s, the heat transfer coefficient increases by 45.92% with the ratio of long axis to short axis. When the inlet velocity is 0.5 m/s, the heat transfer coefficient decreases by 12.96% firstly and increases by 7.74% then. The pressure drop Δp is constant with the increase of the pitch; the increase with the ratio of the long and short axes is reduced by 36.67%. The sensitivity analysis shows that inlet velocities influence the heat transfer coefficient and pressure drop more than structural parameters and the ratio of long axis to short axis of structural parameters influences output parameters more than the pitch, which provides theoretical guides for structure improvement and inlet velocities selection of RBHE given structure and inlet velocities. Three sets of optimal results were obtained by employing multi-objective genetic algorithms to maximize the heat transfer coefficient and minimize the pressure drop simultaneously on response surfaces. Compared with the original structure, the heat transfer coefficient increases averagely by 19.17%; the pressure drop decreases by an average of 5.74%; the comprehensive performance h/Δp is enhanced by 26.42%.

Optimization investigation on configuration parameters of spiral-wound heat exchanger using Genetic Aggregation response surface and Multi-Objective Genetic Algorithm

Parametric optimization of a spiral ground heat exchanger by response surface methodology and multi-objective genetic algorithm

Non-linear mapping and multi-objective optimization of leading flow structure in plate-fin heat exchanger

Multi-Objective Optimization on the Structural Parameters of Spiral Wound Heat Exchanger

Multi-objective optimization of a double helical coil heat exchanger using response surface method and genetic algorithm

Configuration optimization of shell-and-tube heat exchangers with helical baffles using multi-objective genetic algorithm based on fluid-structure interaction

Fluid-thermal-structural Analysis and Structural Optimization of Spiral-Wound Heat Exchanger

Optimization Investigation on Configuration Parameters of Serrated Fin in Plate-Fin Heat Exchanger Using Genetic Algorithm

Multi-objective optimization of helically coiled tube heat exchanger based on entropy generation theory

Numerical Investigation on the Multi-Objective Optimization of a Shell-and-tube Heat Exchanger with Helical Baffles

Application of Response Surface Method and Multi-Objective Genetic Algorithm to Configuration Optimization of Shell-and-tube Heat Exchanger with Fold Helical Baffles

Optimization Analysis of Thermodynamic Characteristics of Serrated Plate-Fin Heat Exchanger

Structural parameter design of welded plate heat exchanger based on multi-objective optimization algorithm

Intelligent optimization design of shell and helically coiled tube heat exchanger based on genetic algorithm

Optimization of thermal and flow characteristics of plate heat exchanger with variable structure parameter

Configuration Parameters Design and Optimization for Plate-Fin Heat Exchangers with Serrated Fin by Multi-Objective Genetic Algorithm

Multi-objective Optimization of Helical Coil Steam Generator in High Temperature Gas Reactors with Genetic Algorithm and Response Surface Method

Optimization of Twist Winglets–Cross-Section Twist Tape in Heat Exchangers Using Machine Learning and Non-Dominated Sorting Genetic Algorithm II Technique

Optimization Design for Offset Fin in Plate Heat Exchanger with Genetic Algorithm

Multi-objective optimization on shell-side performance of rod-baffle heat exchangers with twisted oval tubes

Performance Comparison Of Particle Swarm Optimization And Genetic Algorithm In Rolling Fin-Tube Heat Exchanger Optimization Design