Abstract:Utilization of inherent active minerals in coal is an effective strategy for high-performance activated carbon (AC) production, such as calcite and pyrite. In this research, ACs were prepared through blending demineralized Ningxia coal with calcite (CaCO3, 0-8 wt.%) and pyrite (FeS2, 0-3 wt.%). The combined effect of inherent pyrite and calcite in coal on the as-prepared AC's texture and SO2 and/or NO removal performance was discussed. The results indicated that: (1) The combined effect of calcite and pyrite showed nonlinearly on weight loss and burn -off, and reduced AC's yield. The impact of calcite on pore structure was more evident than pyrite. Meanwhile, calcite and pyrite enhance the content of C-O (C 1 s) and pi-pi*, and new mineral CaS could be formed through interaction between calcite and pyrite; (2) Calcite and pyrite promote AC's SO2 and NO removal ability evidently. Pyrite and calcite regulate physiochemical texture, and the physical and chemical adsorption of SO2/ O2/H2O was enhanced. Meanwhile, iron and calcium ingredients in AC catalyzed desulfurization. CaO could participate in the SO2 removal process. Fe2O3 oxidized SO2 to SO3 and then forms H2SO4 rapidly, meanwhile, a redox cycle of Fe3+ and Fe2+ was established. Enhancement of NO removal was more evident than SO2, which was mainly due to Fe2O3 being helpful to oxidizing NO to NO2, and calcium components could enhance the adsorption of NH3 and NO and finally promote "fast SCR"; (3) During simultaneous desulphurization and denitrification, sulfur capacity was obviously enhanced and NO conversion was declined. The mechanism was proposed as follows: the existence of NH3 could enhance the SO2 adsorption through chemisorption and/or catalytic oxidization; Due to the competitive adsorption of SO2, denitrification declined. This research could guide high-performance AC production by utilizing high-inorganic-calcium/iron/sulfur coal.

Cyclic Regeneration of Pyrolusite-Modified Activated Coke by Blending Method for Flue Gas Desulfurization

Activated Coke Prepared by Circulating Fluidized Bed Coal Pyrolysis Semi-coke for Desulphurization

Evolution of the physicochemical properties and SO2 adsorption performance of powdered activated coke during adsorption–desorption cycle

Microwave Irradiation Induced High-Efficiency Regeneration for Desulfurized Activated Coke: A Comparative Study with Conventional Thermal Regeneration

Study on thermal regeneration of saturated activated coke coupled with SO2 carbothermal reduction to produce elemental sulfur

Improving So2 And/Or No Removal by Activated Carbon Through Comprehensive Utilization of Inherent Pyrite and Calcite in Coal

Resource Utilization of Exhausted Activated Coke As the Efficient Material for Simultaneous Removal of Cos and H &Lt;sub>2</sub>s

Ore sintering flue gas desulfurization and its resoureilization by using pyrolusite

Hierarchical pore configuration in activated coke boosting direct desorption of desulfurization product H2SO4: A combined experimental and computational investigation

Desulfurization Performances of Activated Coke Prepared from Fine Blue-Coke

Changes of activated coke properties in cyclic adsorption treatment of flue gases

Performance on desulfurization and denitrification of one-step produced activated carbon for purification of sintering flue gas

Insights into the effect of regeneration temperature on physicochemical properties and SO2 removal over powdered activated coke

Insight into the enhancing activity and stability of Ce modified V2O5/AC during cyclic desulfurization-regeneration-denitrification

A Research on the Regeneration of Deactivated SCR Catalyst Used in Coal-Fired Plant

Effect of Na 2 CO 3 , HF, and CO 2 Treatment on the Regeneration of Exhausted Activated Carbon Used in Sintering Flue Gas

Optimization of pyrolysis for MgO recycling in magnesia-based flue gas desulfurization

Deactivation and Regeneration of Commercial SCR Catalysts Used in a 660 MW Coal-Fired Power Plant

Comparative study on the preparation of powdered activated coke for SO2 adsorption: One-step and two-step rapid activation methods

Resource utilization of semi-dry flue gas desulfurization ash by thermal treatment on sintering machine

Effect of Multi-Cycle Desulfurization and Regeneration on Surface Structure and Regeneration Performance of Desulfurizer Ce-Fe/Zno