Abstract:The current research was focused on the mechanism and kinetics of Cobalt, Iron, and their alloy: cobalt ferrite electrodeposition from its dissolved ions in a eutectic mixture called Reline (formed by choline chloride and urea), an ionic liquid non-toxic and biodegradable, varying the hydrodynamic conditions, which had not been reported previously from non-aqueous solvents. This kind of alloy has been widely studied, mainly for its hard-magnetic properties that have improved very large amounts of components like information storage systems. Reline is part of the ionic liquids known as deep eutectic solvents (DES) with low vapor pressure, a wide potential range, a high electrical and thermal conductivity, lower cost, and greater stability. Cobalt, Iron, and cobalt ferrite nanoparticles, CoFeNPs, were electrodeposited onto a glassy carbon electrode (GCE), from a DES formed by choline chloride and urea (Reline) in a 1:2 molar ratio containing 50 mM cobalt chloride, CoCl2, and 50 mM iron chloride, FeCl3, at 70 °C. Cyclic voltammetry was used to study the convection effect on the electrodeposition from DES and ascertain the electrodeposition potential range of redox reactions. The chronoamperometric results led to determining the mechanism involved during these electrochemical phase formation processes and the kinetic parameters, such as: the number density of active sites (N0), nucleation rate (A), water reduction constant rate (kwr) and diffusion layer thickness (δ), as a function of the electrode angular speed and electrodeposition potential. These kinetic parameters were obtained from non-linear to the experimental potentiostatic current transients using the Hyde and Compton theoretical equation [1] for Co, Fe and Co-Fe systems under forced convection. The alloyed Fe-Co electrodeposits without agitation were analyzed by the model of Díaz-Morales et al. [2]. On the other hand, the Fe and Co deposits were studied with Heerman and Tarallo model [3]; complemented with M. Palomar – Pardavé et al. model [4] for concomitant reactions. The dominant mechanism of the electrodeposition processes for the three systems was the multiple nucleation with diffusion-limited 3D growth It was found that A increased with the applied potential and that the diffusion layer thickness increased with decreasing angular speed. Water reduction was recognized as concomitant processes in the systems without agitation for the highest applied potentials which were catalyzed mainly by Co deposits. The electrodeposits were characterized by X-rays Energy Dispersive Spectroscopy (EDX) - Scanning Electron Microscopy (SEM) and X-Ray photoelectron spectrometry (XPS) revealed the presence of Co-Fe oxides with spherical morphology, cobalt hydroxide, and metallic cobalt.

Electrochemical Behavior of Dy(III) and Dy-Fe Alloys Preparation by Co-Reduction in Molten Fluoride Salts

Electrochemical Behavior of Dy(III) and Formation of Dy-Zn Alloy by Co-Reduction with Zn(II) in Eutectic NaCl-KCl Melts

Electrodeposition of magnesium–lithium–dysprosium ternary alloys with controlled components from dysprosium oxide assisted by magnesium chloride in molten chlorides

Electrochemical recovery of dysprosium from LiCl-KCl melt aided by liquid Pb metal

Mechanism of Dy3+ and Nd3+ Ions Electrochemical Coreduction with Ni2+, Co2+, and Fe3+ Ions in Chloride Melts

Electrolytic separation of Dy from Sm in molten LiCl-KCl using Pb-Bi eutectic alloy cathode

Influence of the material processing on the electrochemical properties of cobalt-free Ml(NiMnAlFe)5 alloy

Electrochemical behavior of Sm(III)/Sm(II) and extraction of Sm on reactive electrode from molten LiF-BeF 2

Electrochemical properties and extraction of Dy on liquid Sn electrode in LiCl–KCl molten salt

Low Temperature Electrochemical Properties of LaNi4.6−xMn0.4Mx (m=fe or Co) and Effect of Oxide Layer on EIS Responses in Metal Hydride Electrodes

Influencia de la convección forzada sobre la cinética de electrodeposición de Fe, Co, y Fe-Co en el disolvente eutéctico profundo Cloruro de Colina-Urea

Investigation into cathodic reduction process of Yb(III) ion in (LiF-YbF3)eut.-Yb2O3 molten salt system

Electrodeposition of Dy and its grain boundary diffusion behavior of sintered NdFeB magnets

The role of electrolyte ratio in electrodeposition of nanoscale Fe Cr alloy from choline chloride-ethylene glycol ionic liquid: A suitable layer for corrosion resistance

Effect of Dy Doping on Magnetostrictive and Mechanical Properties of Fe 83 Ga 17 Alloy

Electroactive Endohedral Metallofullerene Film Electrodes in Aqueous Solutions

Facile Room-Temperature Electrodeposition of Rare Earth Metals in a Fluorine-Free Task-Specific Electrolyte

Solidification Behavior of Dy-Tb-Fe Alloys through Experimental Study and Thermodynamic Calculation

Preparation of Sm-Co Alloy by Electrodeposition in DMF Solution

Effects of Dy71.5Fe28.5 Intergranular Addition on the Microstructure and the Corrosion Resistance of Nd–Fe–B Sintered Magnets

A formal Fe(III/V) redox couple in an intercalation electrode