Abstract:This article describes a general method for studying the behavior of converters with three discontinuous conduction modes as automatic power factor correctors (PFCs). Some converters with a single discontinuous conduction mode (such as Buck-Boost, Flyback, SEPIC, Ćuk, and Zeta converters) can behave as automatic PFCs when operating in that discontinuous conduction mode, with a nearly constant duty cycle during each cycle of the line voltage. There are also dc/dc converters that, due to multiple diodes and inductors, can operate in different discontinuous conduction modes. A systematic method for studying these three discontinuous conduction modes was recently presented. This article extends that method to using the aforementioned dc/dc converters as part of an ac/dc converter with low harmonic injection in the line, identifying when the converters behave as "ideal automatic resistor emulators" (i.e., configuring ideal automatic PFCs) and when they behave as "quasi-ideal automatic resistor emulators" (i.e., as quasi-ideal automatic PFCs). As an example, the article examines a SEPIC converter used as a resistor emulator. In this case, three discontinuous conduction modes are possible, if the inductance of the input inductor is low enough to allow the input bridge rectifier diodes to stop conducting when the transistor is off. The study allows us to determine of the line current waveform when the converter operates in any of the possible discontinuous conduction modes. The results show that quasi-ideal automatic PFC behavior can be achieved in discontinuous conduction modes with low inductance values. Moreover, the results for the SEPIC can be easily extended to the Ćuk converter operating in the same manner. Finally, the theoretical predictions for the line current from the proposed study were verified through simulation using PSIM (in the case of both the SEPIC and Ćuk topologies), and through experimentation (in the case of SEPIC).

A Series Diode Method of Suppressing Parasitic Oscillation for Boost PFC Converter Operated in Discontinuous Conduction Mode

A Digital Control Method for PFC Achieving High Power Factor

Detailed Oscillation Analysis and Parameter Selection Principle for Boost PFC Converter with RC Snubber Operated in DCM

Design and Analysis of Single-Stage Power Factor Correction Converter with a Feedback Winding

An Improved Power-Decoupling Scheme with Grid Inductor Phase-Shift Modification for Single-Phase Converter

Accurate Operating Analysis of Boundary Mode Totem-Pole Boost PFC Converter Considering the Reverse Recovery of Mosfet

Effect of Parasitic Parameters on Current Distortion of Boost PFC Circuit

Research on A Novel Three-Phase Single-Stage Boost Dcm Pfc Topology and the Dead Zone of Its Input Current

Analysis and Optimization of High-Frequency Switching Oscillation Conducted CM Current Considering Parasitic Parameters Based on a Half-Bridge Power Module

Analysis and Control of Parasitic Oscillation of the Output Rectifier Bridge in DC/DC Converter

Analysis of Boost PFC Converters Operating in the Discontinuous Conduction Mode

Modified Harmonic Current Control and Load Range Extension Method for Single-Stage Isolated DCM Boost AC-DC Converter

An Improved Single Phase Bridgeless PFC Converter

Series-Capacitor-Based Buck PFC Converter With High Power Factor and Ultrahigh Step-Down Conversion Ratio

A Scheme to Improve Power Factor and Dynamic Response Performance for CRM/DCM Buck–Buck/Boost PFC Converter

A Systematic Method for Studying the Use of DC/DC Converters With Three Discontinuous Conduction Modes as Automatic PFCs

Dynamic Performance Improvement of Diode–capacitor-Based High Step-up DC–DC Converter Through Right-Half-Plane Zero Elimination

Design of CCM boost converter utilizing fractional-order PID and Lyapunov-based PID techniques for PF correction

A New Control Method for Boost Converter in Discontinuous Conduction Mode with Synchronous Rectification and Zero Voltage Switching

Optimal Switching Frequency Variation Range Control for Critical Conduction Mode Boost Power Factor Correction Converter

Analysis of Medium-Frequency Oscillation in the Boost Power Factor Correction Converter with Average Current Mode Control