Abstract:The switching oscillations and voltage overshoots excited by ultrafast switching transients are urgently required to be overcome for SiC mosfet. Herein, the C-RC snubber is employed to address these adverse issues. An optimized C-RC snubber design is proposed, which can not only suppress the switching oscillation and overvoltage, but also effectively reduce the snubber loss compared with the dc-link RC snubber. This will be beneficial to the actual application of this snubber into the high-power and high-frequency field. For the turn-off overvoltage, the varying tendency of the overshoot with snubber parameters are analyzed according to the equivalent impedance network so that the parameter selection principle can be obtained preliminarily. Then, the C-RC snubber parametric region where both oscillations and overvoltages can be sufficiently suppressed is established using the root locus. Distinctive from the prior-art C-RC design to seek the peak impedance, the proposed switching ringing suppression method is developed by the way of actively assigning poles of fifth-order system to tune an optimal damping ratio. Then, the final design can be determined by minimizing the snubber loss within the obtained parametric range. Finally, the influence of snubber circuit on overvoltage, switching oscillation, and snubber loss are illustrated and verified in detail using the double-pulse tests. Moreover, the application of C-RC snubber in the chopper circuit further highlights its superiority of low snubber loss.

Detailed Oscillation Analysis and Parameter Selection Principle for Boost PFC Converter with RC Snubber Operated in DCM

Study of a Single-stage Three-phase PFC DC/DC Converter With Series-parallel Connected Transforms

Analysis and Design for Single-Phase Three-Level Boost PFC Converter with Quasi-Static Model

Design and Analysis of Single-Stage Power Factor Correction Converter with a Feedback Winding

Evaluation of Output Filter Capacitor Current Ripples in Single Phase PFC Converters

Accurate Operating Analysis of Boundary Mode Totem-Pole Boost PFC Converter Considering the Reverse Recovery of Mosfet

A Series Diode Method of Suppressing Parasitic Oscillation for Boost PFC Converter Operated in Discontinuous Conduction Mode

A Scheme to Improve Power Factor and Dynamic Response Performance for CRM/DCM Buck–Buck/Boost PFC Converter

An improved control scheme for buck PFC converter for high efficiency adapter application

Analysis and Design of a ZVS Boost/buck-Boost Dual Mode PFC Converter with Universal Input and Wide Output Voltages

Analysis and Suppression of Common-Mode EMI Noise in 1 MHz 380 V-12 V DCX Converter with Low NFoM Devices

A Simplified Input Filter Capacity Current Compensation Scheme for 360–800 Hz CRM Totem-Pole PFC with Si MOSFETs

An Optimal Peak Current Mode Control Scheme for Critical Conduction Mode (crm) Buck Pfc Converter

Design of Interleaved Boost PFC Converter with Peak Current Control

Analysis And Optimizing Method Of Transient Performance For Lcl-Based Grid-Connected Inverter With Passive Damping

C-RC Snubber Optimization Design for Improving Switching Characteristics of SiC MOSFET

Phase Leading Input Current Compensation for Crm Boost Pfc Converter

Steady-State and Dynamic Study of One-Cycle-controlled Three-Phase Power-Factor Correction

A Symmetrical Control Scheme for a Resonant Switched-Capacitor Converter with Inverted Output Voltage

Phase-by-Phase Discrete Mapping Modeling and Bifurcation Analysis of Boost PFC Cascaded Buck Converter System

A Novel PCCM Boost PFC Converter With Fast Dynamic Response