Abstract:Introduction: Sulfolane (SL), having an edge of low melting point over other sulfones, has been adopted as an electrolyte co-solvent for lithium-ion battery (LIB), as it exhibits high stability against oxidation and combustion while not causing much side effects to the battery electrochemistry. It is therefore expected that SL may serve as a safety-enhancing agent in sodium-ion battery (SIB). To evaluate the effect of SL content on the behavior of common carbonate-based sodium electrolytes as well as the compatibility of SL-based electrolytes with NaNi1=3Mn1=3Co1=3O2 (NaNMC) cathode, mixtures of 0, 10, 20, 30 or 50% vol. SL and each of the following, EC:PC 1:1 vol. (EP11), EC:DMC 1:1 vol. (ED11), EC:PC:DMC 1:1:3 vol. (EPD113) and EC:PC:DMC 3:1:1 vol. (EPD311), with or without 1M NaClO4, were studied with regard to both inherent properties and performance in NaNMC half-cells. Methods: Solvent flammability was evaluated via the self-extinguishing time (SET) and ignition time indexes. Conductivity and viscosity were respectively measured by Electrochemical Impedance Spectroscopy (EIS) and Ostwald method. Electrochemical techniques, i.e. Cyclic Voltammetry (CV) and Galvanostatic Cycling with Potential Limitation (GCPL), were used to test the sodium-ion battery performance. Results: A moderate amount of SL (typically below 30% vol.) proved to enhance both electrolyte non-flammability and self-extinguishing behavior, while maintaining an acceptable compromising rate in viscosity and conductivity. Amongst 30%-SL electrolytes, EPD311-based ones allow the best Na+ diffusion when combined with NaNMC cathode in sodium half-cell configuration. The corresponding system gives satisfactory performance: initial specific capacity of 97 mAh.g-1, 92% capacity retention, and above 90% reversibility after 30 cycles at C/10 rate. Conclusion: SL can be used as a stabilizing co-solvent for SIB, but its content should be limited to below 30% vol. to ensure its effectiveness.

Improving High-Voltage Performance of Lithium-Ion Batteries with Sulfolane As an Electrolyte Additive

A Low-Concentration Sulfone Electrolyte Enables High-Voltage Chemistry of Lithium-Ion Batteries

Improving the Cycling Performance of High-Voltage NMC111 || Graphite Lithium Ion Cells by an Effective Urea-Based Electrolyte Additive

The Synergistic Effect of Lithium Bis(fluorosulfonyl)imide and Lithium Nitrate for High-Performance Lithium Metal Anode

Organic salts with unsaturated bond and diverse anions as substrates for solid electrolyte interphase on graphite anodes

Sulfolane‐Graphite Incompatibility and Its Mitigation in Li‐ion Batteries

Electrochemical performance of sulfone-based electrolytes in sodium ion battery with NaNi1/3Mn1/3Co1/3O2 layered cathode

Lithium Dendrite Suppression and Cycling Efficiency of Lithium Anode

An In-Situ Synergistic Enhancement Strategy from G-C3n4 and PDOL Composite Solid Electrolyte on the Interface Stability of Solid-State Lithium Battery

Microscopic insights into effects of sulfolane additive on Li–S battery electrolyte

Sulfolane as an additive to regulate Zn anode in aqueous Zn-ion batteries

Enhancing Li-S Battery Performance with Limiting Li[N(SO 2 F) 2 ] Content in a Sulfolane-Based Sparingly Solvating Electrolyte

Solid-State Interphases Design for High-Safety, High-Voltage and Long-Cyclability Practical Batteries via Ethylene Carbonate-Free Electrolytes

Enhancing the Stability of High-Voltage Lithium-Ion Battery by Using Sulfur-Containing Electrolyte Additives

Tailored interface composition improves the integrity of electrode/electrolyte interphases for high-voltage Ni-rich lithium metal batteries in a sulfolane-based electrolyte

Electrolyte Optimization to Improve the High-Voltage Operation of Single-Crystal LiNi0.83Co0.11Mn0.06O2 in Lithium-Ion Batteries

Competitive Solvation Enhanced Stability of Lithium Metal Anode in Dual-Salt Electrolyte

Stabilizing Lithium-Oxygen Batteries through In Situ Generated Phenyl/LiF-Rich Hybrid SEI Layer with Sulfonyl Fluoride Electrolyte Additive

Design of Non-Depleting Electrolyte Additive to Prolong the Cycle Life of Practical Lithium-Sulfur Batteries

Improving Cyclic Stability of LiMn2O4/Graphite Battery Under Elevated Temperature by Using 1, 3-Propane Sultone as Electrolyte Additive

Optimized Cycle and Safety Performance of Lithium-Metal Batteries with the Sustained-Release Effect of Nano CaCO3