Abstract:Different forms of Reynolds equation are widely used to predict the performances of foil thrust bearings for air cycle machines. When analyzing bearings operating with highly dense CO2, computational fluid dynamics yields more accurate results, particularly at the high rotational speed. In addition, the structural deformation of the top and bump foils are also considered. For some applications, the high temperature increase caused by the viscous heating effect are also modelled in literature. The multi-physics effects within foil bearings, including the fluid flow, structural deformation and viscous heating create challenges and modelling complexity to accurately predict its performances. The aim of this paper is to review and compare different modelling approaches for foil thrust bearings with CO2 at a range of operating conditions, including loads and rotational speed. For steady state performances, results from turbulent Reynolds equation and computational fluid dynamics are in close agreement for foil thrust bearings operating with low load (large rotor to top foil separations). However, considerable differences exist between turbulent Reynolds equation and computational fluid dynamics method at high loads (small rotor to top foil separation). Here the computational fluid dynamics method must be employed, as the centrifugal inertia effect becomes significant. The top foil deflection need to be considered as the corresponding deformation is significant compared to the initial separation between the rotor and the top foil. At the rotational speed larger than 30000 rpm, the results from the fully fluid-structure-thermal simulations differ from other modelling approaches. The additional deformation caused by temperature increase largely alters the separation between the rotor and top foil. For dynamic performance, the top foil deflection again must be considered as the equivalent stiffness and damping are influenced by bump foil structures. This work provides recommendations for the selection of the suitable modelling approaches for bump-type foil thrust bearings operating with supercritical CO2.

Static Performance of Gas Foil Bearings with Nonlinear Foil Stiffness Model

Performance of Thrust Foil Bearings with Nonlinear Foil Stiffness Model

Dynamic Characteristics of Gas Foil Bearing Based on Bump Foil Stiffness Test

Static Characteristics Analysis of Bump Foil Journal Bearing

Theoretical Study on Static Performance of Double-Bump Foil Bearings

Frictional Analysis on Stiffness and Damping Characteristics of Bump Foil Gas Bearings

Modeling and static characteristics study of the double-layer bump gas foil bearing

Static characterization of bump-type gas foil bearing： intergration of top foil 2-D thick plate model

Dynamic performance of foil bearings with a quadratic stiffness model.

The Effect of Coulomb Friction in Foil Structure on the Static and Dynamic Performance of Bump Foil Journal Bearings

Effect of Bump Structural Friction on the Performance of Bump Foil Bearing and Rotor Dynamic Behavior: Experimental Study

Effects of Coulomb Friction in Foil Structure on Foil Journal Bearing Performance

Analysis of Foil Predeformation Influence on the Static Characteristics of Bump Foil Journal Bearings

COMPARISON OF MODELLING APPROACHES FOR BUMP-TYPE FOIL THRUST BEARINGS OPERATING WITH CO2

Experiment of foil friction effect on static stiffness and lift off speed of bump foil journal bearing

Numerical Investigation of Bump Foil Configurations Effect on Gas Foil Thrust Bearing Performance Based on a Thermos-Elastic-Hydrodynamic Model

The Static Load Performance Research of Dynamic Radial Bump Foil Bearing

Effects of Shear Stiffness in Top Foil Structure on Gas Foil Bearing Performance Based on Thick Plate Theory

A nonlinear model for dynamic performance analysis of gas foil bearing-rotor system considering frictional contacts

Effects of Structure Parameters on Static Performance of Gas Foil Bearings Based on a New Fully Coupled Elastic–Aerodynamic Model

An Efficient Three-Dimensional Foil Structure Model for Bump-Type Gas Foil Bearings Considering Friction