Abstract:Fouling control strategies play a crucial role in membrane distillation (MD) process, primarily due to the significant limitation of fouling during the scaling-up process. The utilization of microbubbles (MBs) aeration has exhibited promising potential in mitigating membrane fouling when treating high salinity wastewater. Aeration can introduce gas-liquid two-phase flow on the membrane surface, thereby increasing the membrane surface shear force. The mechanism of aeration technology for controlling fouling includes the following points: introduction of gas-liquid two-phase flow; physical substitution of concentration polarization layer; pressure pulses caused by bubbles flowing through the membrane surface and increasement of the cross flow velocity. This research aims to optimizing the effect of air MBs with different concentrations and sizes introduced in the feed side on membrane fouling control, we creatively used the method of releasing pressure gradiently to achieve size regulation of MBs within a certain range for the first time, firstly regulated the generation of MBs by manipulating gas flow rate and release pressure. Under the optimal condition of 40 mL/min and 0.6 MPa, it will yield concentration of 1.58 × 10 4 /mL and D50 Sauter size of 64.69 μm MBs with pure water permeance flux of 12.32 kg/(m 2 ·h). It was observed that higher gas flow rates primarily increased MBs concentration, while lower pressures predominantly reduced MBs size through the method of inline imaging. Experimental results indicated that introduction of MBs can slightly improve the temperature polarization coefficient and mass transfer coefficient under different operating modes. Consequently, further investigations focused on the influence of MBs characteristics on different fouling control. All conditions reach 99 % rejection for inorganic salt and HA. This study provided empirical evidence that higher concentration and larger size of MBs intensify the gas-liquid two-phase flow disruption and exhibit a better shear effect on scaling phenomena, which yield advantageous outcomes in terms of augmenting permeance flux and water vapor production, with permeance flux increased from 40.12 % to 55.42 % for inorganic fouling and increased from 68.35 % to 80.15 % for inorganic and HA fouling. These results were confirmed via membrane surface using scanning electron microscopy and energy dispersive spectroscopy. In summary, this research aided in identifying appropriate operating conditions for mitigating inorganic and composite scaling by implementing air-infused MBs in direct contact membrane distillation (DCMD), which provides scientific and technical guidance for controlling fouling in MD in practical applications.

Enhancement of MSF Using Microbubbles

Improvement of a multi-stage flash seawater desalination system for cogeneration power plants

A Review of Heterogeneous Nucleation of Calcium Carbonate and Control Strategies for Scale Formation in Multi-Stage Flash (MSF) Desalination Plants

Economic Analysis of an Improved Multi-stage Flash Desalination System for Seawater

Development of microbubble generation method

Micro‐nanobubbles assisted fouling reduction in membrane distillation for desalination

Experimental and Mathematical Study of the Spray Flash Evaporation Phenomena

Mathematical study of spray flash evaporation in a spray-assisted seawater desalination chamber

Experimental investigation on the characteristics of flash evaporation from superheated water jets for desalination

Enhancement of heat transfer coefficient of water desalination in multi-stage flushing using hematite nanofluid

Performance of Dual Multistage Flashing - Recycled Brine and Solar Power Plant, in the Framework of the Water-Energy Nexus

Modelling and simulation of industrial multistage flash desalination process with exergetic and thermodynamic analysis. A case study of Azzour seawater desalination plant

Study on the solar energy flash vaporization-multi-effective distillation seawater desalination system

Innovative stimuli-responsive membrane MSF brine rejection dilution by tertiary treated sewage effluent

Effect of Bubble Characteristics and Nozzle Size on the Membrane Distillation Enhanced by Gas–liquid Two-Phase Flow

Micro-Nano Bubbles Conditioning Treatment of Contaminated Sediment for Efficient Reduction: Dehydration Characteristic and Mechanism

Direct simulation of flashing liquid jets using the MPS method

Vapor Compress Flash: Synthesis and Progress on Seawater Desalination Methods

Water Desalination Using the Once-through Multi-Stage Flash Concept: Design and Modeling

Optimizing fouling mitigation in membrane distillation by controlled microbubble size and concentration

Experimental Validation of a Solar Powered Multistage Flash Desalination Unit with Alternate Storage Tanks