Abstract:This article presents a direct synthesis method for the design of a wideband filtering switch, where p-i-n diodes are incorporated into each resonator. As parasitic parameters are embedded in the p-i-n diodes, an ideal transformer is introduced in each resonator to provide the freedom to designate the proper values for inductances and capacitances in the resonators. According to the rejection specification in the on state, an $N$ th order bandpass filter (BPF) network with $N$ transmission zeros (TZs) is synthesized, followed by a new circuit model extraction procedure to extract lumped circuits in the BPF network. To simplify the network topology, two ideal transformers at input–output port remain after absorbing the ideal transformers between resonators. Then, the lumped circuit model is converted into a distributed circuit model in the synthesis process, maintaining the filtering response in a wide frequency range when the switch is in the on state. Besides, the $N$ TZs of the filtering switch in the off state can be introduced and arranged to suitable positions. Consequently, high isolation within the stopband of the switch in the off state can be achieved. For demonstration purposes, two filtering switches with fractional bandwidths (FBWs) of 30% and 50% are fabricated and measured. Good agreement can be observed between the simulated and measured results, which validates the feasibility of the proposed method.

A Quasi-Elliptic Bandpass Filter-Integrated Single-Pole Double-Throw Switch

3D Heterogenous Integrated Wideband Switchable Bandpass Filter Bank for Millimeter Wave Applications

A Design of V-band Reconfigurable SPDT Switch/Power Divider Based on Slotted SIW

Design of compact dual-band quasi-elliptic filter with high selectivity and wide stopband rejection

Compact dual-band bandpass filter using asymmetrical dual stub-loaded open-loops

Extended Doublet Bandpass Filters Implemented with Microstrip Resonator and Full-/Half-Mode Substrate Integrated Cavities

Novel Quasi-Elliptic Function Bandpass Filter Using Hexagonal Resonators with Capacitive Loading

A Miniaturized Dual‐mode Zeroth‐order Ring Bandpass Filter with One Left‐handed Unit and a Capacitive Stub

Low Insertion-Loss Single-Pole–Double-Throw Reduced-Size Quarter-Wavelength HEMT Bandpass Filter Integrated Switches

Design of compact dual-band switchable bandpass filter

A Wideband Filtering Switch: Its Synthesis and Design

A 12–16 GHz microelectromechanical system-switchable bandpass filter

Design of A Reconfigurable Filtering Switch with Sharp Rejection and Wide Stopband

A Compact Bandpass Filter with Active Switchable Passband Status

A MILLIMETER-WAVE ULTRA-WIDEBAND FOUR-WAY SWITCH FILTER MODULE BASED ON NOVEL THREE-LINE MICROSTRIP STRUCTURE BAND-PASS FILTERS

A DC-50 GHz SPDT Switch with 1.5-dB Insertion Loss and 35-dB Isolation in 65-nm CMOS

Tunable Bandpass Filter Using a Switched Tunable Diplexer Technique.

1.866–2.782-GHz Reconfigurable Filtering Single-Pole-Multithrow Switches Based on Evanescent-Mode Cavity Resonators

Reconfigurable Dual-Band Bandpass Filter with Fully-Switch Operation Using Λ/2 Folded-Resonator with Varactor-Loaded Open-Stub

Dual Mode Bandpass Filter with Switchable Response

Reconfigurable Bandpass Filter With Multi-Band Switching and Band Shiftability