Abstract:A series of experiments has been conducted to investigate the tribological properties of a TiN film sliding against GCr15 steel balls in ambient air, low vacuum and high vacuum environments. Various friction loads and sliding velocities were also applied. The TiN film displays a steady-state friction stage after the running-in stage in all the above environments, while the durations of running-in stages are different. The steady-state friction coefficients of the TiN film were around 0.56 in ambient air and 0.3 in the high vacuum environment (1 × 10−5 mbar). In the low vacuum (1 × 10−2 mbar) environment, a low friction coefficient (around 0.19) was attained for all the friction tests on TiN film, irrespective of the applied load and sliding velocity. In the meantime, it was noticed that the applied loads and the sliding velocities would change the duration of the running-in stage before reaching the low friction coefficient. It is revealed by the analysis of wear tracks that the metal oxides induced by the tribo-chemical effect at the friction interface play an important role in affecting the tribological behaviors of the TiN films in different environments. The Raman results show that the main component of the metal oxides is hematite (α-Fe2O3), and the amount of iron oxide is related to the friction environment. The composition and quantity of iron oxides produced by the interfacial tribo-chemical effect affect the tribological behavior. The results also show that the mechanical wear process at the friction interface displays a polishing effect, which would reduce the surface roughness. The mechanical wear performance varies under different loads and velocities. The tribological tests results indicate that the interfacial tribo-chemical effect and mechanical wear process should be considered together rather than individually to interpret the tribological behaviors of TiN films in different environments.

Tribological Properties of Surface Nanocrystalline Martensite Steel in Vacuum

Effect of Grain Size on the Friction-Induced Martensitic Transformation and Tribological Properties of 304 Austenite Stainless Steel

Investigation on triboelectrification behavior of surface nanocrystallization of medium carbon steel

A Study of Friction and Wear Behavior of Nitrided Layer on 2cr13 Steel in Vacuum

Effect of a Micro-Textured Surface with Deposited MoS2-Ti Film on Long-Term Wear Performance in Vacuum

Influence of Interfacial Tribo-Chemical and Mechanical Effect on Tribological Behaviors of TiN Film in Different Environments

Effect of Nanoscale Surface Roughness on Sliding Friction and Wear in Mixed Lubrication

Tribological behavior of steel surface texturing by laser in graphite or oil lubrication

Additional Tribological Effect of Laser Surface Texturing and Diamond-Like Carbon Coating for Medium Carbon Steel at Near Room Temperature

Grease-lubricated Tribological Behaviour of Nitrided Layer on 2cr13 Steel in Vacuum

Effect of Variation of Martensite with a Constant Carbon Content on Mechanical Behavior and Sliding Wear of Dual Phase Steels

Wear Behavior of Plasma-Nitrided 2cr13 Martensitic Stainless Steel under Air and Vacuum

MXene/graphene oxide nanocomposites for friction and wear reduction of rough steel surfaces

High-Speed Dry Tribological Behaviors of Crnimo Steel in Nitrogen and Oxygen Atmospheres

Formation of Nanocrystallized Structure in Worn Surface Layer of T10 Steel Against 20crmnti Steel During Dry Rubbing

Tribological Behaviors at High Load of Mos(X)/Au Films in Vacuum

Relationship between discoloration, condensation, and tribology behavior of steel surfaces at cryogenics in vacuum

A study on the relationship between the magnetic properties of a worn surface layer and the wear resistance

Effect of Sliding Velocity in Vacuum on Tribological Behavior of Nitrided 2cr13 Steel

Tribological Behavior of MoS2/Graphite Sputtering Coatings under Various Load in Vacuum

DRY SLIDING WEAR OF Ti-6Al-4V ALLOY AT LOWTEMPERATURE IN VACUUM