Abstract:A strain-insensitive temperature sensor based on multimode interference using standard multimode fibers (MMFs) is proposed according to the comprehensive study of the characteristics of the MMFs. The temperature and strain dependences on the core diameter, numerical aperture (NA), and the length of the MMF section in the single-mode--multimode--single-mode (SMS) fiber structure are investigated experimentally. The results indicate that the larger core diameter of the MMF leads to higher temperature sensitivity but lower strain sensitivity (absolute values); the higher NA does not influence the temperature sensitivity but results in higher absolute value of strain sensitivity; the longer MMF section brings lower temperature sensitivity but does not have an impact on strain sensitivity. These findings also contribute to the theoretical analysis of the length dependence in the SMS fiber sensors. Besides, the results of the characterization study show that the strain sensitivity is relatively low, which brings a possibility to develop a strain-insensitive temperature sensor. The proposed sensor is used for temperature sensing while the strain is constantly applied from 0 to 1100 $\mu\epsilon$ with steps of 100 $\mu\epsilon$. The measured results are consistent with the comprehensive study. The mean temperature sensitivity is 6.14 pm/$^{\circ}$C with a standard deviation of 0.39 pm/$^{\circ}$C, which proves that the proposed temperature sensor exhibits good stability and is insensitive to strain. We expect that these results will provide a profound guideline to fiber sensors based on multimode interference.

Dual-Parameters Measurement With Enhanced Sensitivity By Introducing Higher-Order Interference Modes Using Twisted Multimode Fiber

Strain Sensor Based on Gourd-Shaped Single-Mode-multimode-single-mode Hybrid Optical Fibre Structure.

Simultaneous Measurement of Displacement and Temperature Based on Two Cascaded Balloon-Like Bent Fibre Structures

A Dual-Parameter Active Fibre Sensor Based on Modal Interference in Few-Mode Fibres

Fiber-optic multimode interference sensing: comprehensive characterization and its potential for strain-insensitive temperature sensing

Multi-parameter Measurement Sensor Based on No-Core Fiber

An In-Line Fiber-Optic Modal Interferometer for Simultaneous Measurement of Twist and Ambient Temperature

High-Sensitivity Strain and Temperature Simultaneous Measurement Sensor Based on Multimode Fiber Chirped Long-Period Grating

An Integrated Fiber Michelson Interferometer Based on Twin-Core and Side-Hole Fibers for Multiparameter Sensing

Multi-parameters SMS optical fiber sensing by employing SCBSS signal processing technique

A Spiral-Polished Fiber Sensor for Strain and Temperature Measurement

bronchitis . Atopy , smoking , and chronic

ALLOMETRIC EXPONENTS SUPPORT A 3/4-POWER SCALING LAW

Optical Fiber Sensor for Temperature and Strain Measurement Based on Multimode Interference and Square-Core Fiber

Simultaneous strain and temperature measurement by cascading few-mode fiber and single-mode fiber long-period fiber gratings

Optical Fiber Sensor for Curvature and Temperature Measurement Based on Anti-Resonant Effect Cascaded with Multimode Interference

Temperature and Strain Sensor Based on a Few-Mode Photonic Crystal Fiber

Simultaneous temperature and strain sensing using few-mode fiber in a single-ended BOTDA system

Dual-Parameter Sensing of Parallel Fiber Sagnac Interferometer Based on Vernier Effect

Interferometric Fiber Optic Surface Plasmon Resonance Sensor for Temperature and Strain Measurement

High Sensitivity Strain Sensors Using Four-Core Fibers through a Corner-Core Excitation