Abstract:Superconducting nanowire single photon detectors (SNSPDs) promise to combine near-unity quantum efficiency with >100 megacounts per second rates, picosecond timing jitter, and sensitivity ranging from x-ray to mid-infrared wavelengths. However, this promise is not yet fulfilled, as superior performance in all metrics is yet to be combined into one device. The highest single-pixel detection efficiency and the widest bias windows for saturated quantum efficiency have been achieved in SNSPDs based on amorphous materials, while the lowest timing jitter and highest counting rates were demonstrated in devices made from polycrystalline materials. Broadly speaking, the amorphous superconductors that have been used to make SNSPDs have higher resistivities and lower critical temperature (Tc) values than typical polycrystalline materials. Here, we demonstrate a method of preparing niobium nitride (NbN) that has lower-than-typical superconducting transition temperature and higher-than-typical resistivity. As we will show, NbN deposited onto unheated SiO2 has a low Tc and high resistivity but is too rough for fabricating unconstricted nanowires, and Tc is too low to yield SNSPDs that can operate well at liquid helium temperatures. By adding a 50 W RF bias to the substrate holder during sputtering, the Tc of the unheated NbN films was increased by up to 73%, and the roughness was substantially reduced. After optimizing the deposition for nitrogen flow rates, we obtained 5 nm thick NbN films with a Tc of 7.8 K and a resistivity of 253 μΩ cm. We used this bias sputtered room temperature NbN to fabricate SNSPDs. Measurements were performed at 2.5 K using 1550 nm light. Photon count rates appeared to saturate at bias currents approaching the critical current, indicating that the device's quantum efficiency was approaching unity. We measured a single-ended timing jitter of 38 ps. The optical coupling to these devices was not optimized; however, integration with front-side optical structures to improve absorption should be straightforward. This material preparation was further used to fabricate nanocryotrons and a large-area imager device, reported elsewhere. The simplicity of the preparation and promising device performance should enable future high-performance devices.

Superconducting Nanowire Single-Photon Detector on Aluminum Nitride

NbN Superconducting Nanowire Single-Photon Detector Fabricated on MgF2substrate

High Efficiency, Large-Active-area Superconducting Nanowire Single-Photon Detectors

Single Photon Detectors Based on Superconducting Nanowires over Large Active Areas

Doped Niobium Superconducting Nanowire Single-Photon Detectors

Design of NbN superconducting nanowire single photon detectors with enhanced infrared photon detection efficiency

NbTiN superconducting nanowire detectors for visible and telecom wavelengths single photon counting on Si3N4 photonic circuits

Fabrication Process Yielding Saturated Nanowire Single-Photon Detectors with 24-Ps Jitter

NbN Superconducting Nanowire Single-Photon Detector With 90.5% Saturated System Detection Efficiency and 14.7 ps System Jitter at 1550 nm Wavelength

Nb$_x$Ti$_{1-x}$N low timing jitter single-photon detectors with unity internal efficiency at 1550 nm and 2.5 K

NbN superconducting nanowire single photon detector with efficiency over 90% at 1550 nm wavelength operational at compact cryocooler temperature

Mid-infrared characterization of NbTiN superconducting nanowire single-photon detectors on silicon-on-insulator

High performance NbN nanowire superconducting single photon detectors fabricated on MgO substrates

Fabrication of Superconducting Niobium Nitride Nanowire with High Aspect Ratio for X-ray Photon Detection

Superconducting nanowire single-photon detectors with saturated quantum efficiency at 1550 nm on single-crystal diamond substrates

Bias Sputtered Nbn and Superconducting Nanowire Devices

A Superconducting Nanowire Single Photon Detector on Lithium Niobate

NbN thin films grown on silicon by molecular beam epitaxy for superconducting detectors

Sputtered NbN films for ultrahigh performance superconducting nanowire single-photon detectors

High performance fiber-coupled NbTiN superconducting nanowire single photon detectors with Gifford-McMahon cryocooler

Superconducting nanowires for detecting single photons at telecommunication wavebands