Abstract:Distributed electro-hydraulic braking systems (DEHB) are brake-by-wire systems for new energy and intelligent vehicles. Brake actuators control the system braking pressure, so the pressure control of the brake actuator is a key part of the system. The research objective of this study is to achieve fast, stable and accurate system pressure control. A pressure control actuator is tested in bench tests, including open-loop and close-loop tests. In the open-loop tests, the highest braking pressure generated by the actuator exceeds 12 MPa with 160 ms needed for the pressure to rise to 10 MPa. The tests show that the open-loop performance of the brake actuator meets the open-loop specifications. A gain-scheduling proportional integral (PI) controller is used for the close-loop pressure control. The rise time for step responses under 6.5 MPa is less than 161 ms, the time lag for an 8 Hz sine response under 6 MPa is less than 17.8 ms, the step response overshoot is less than the minimum of 0.5 MPa and 15% of the step amplitude, and the root-mean-square errors for normal and pumped braking are less than 0.1 MPa and 0.2 MPa. Thus, the tests show that the response speed as well as the stability and accuracy of the pressure control satisfies the close-loop specifications. Tests on stalling of the actuator motor for half an hour show that the heat dissipation of the electronic control unit circuit board is good, which indicates that the electronic control unit circuit board can continuously work with large currents.

Research on a New Direct Drive Electro-Hydraulic Proportional Pressure Valve for Aircraft Braking System

Design and Simulation of a High Pressure Proportional Pneumatic Pressure Reducing Valve

Design and Simulation of Pneumatic Proportional Extra-High Pressure Valve

Research on control characteristic and compensation of water hydraulic proportional pressure relief valve

Simulation and Experiment on Static Characteristic of Water Hydraulic Proportional Pressure Relief Valve

Design and Characteristics Analysis of a High Precision Pneumatic Proportional Pressure Valve

Modelling And High-Precision Constant Pressure Control Of The Pneumatic Suspension System

An Experimental Study on Hysteresis Characteristics of a Pneumatic Braking System for a Multi-Axle Heavy Vehicle in Emergency Braking Situations

Modeling and characteristics investigation on a new pneumatic proportional pressure valve

Hydraulic-feedback Proportional Valve Design for Construction Machinery

Development of a novel high pressure electronic pneumatic pressure reducing valve

Modeling and Adaptive Control of the Electro-Hydraulic Braking System of Low-Floor Vehicle

Research on the Characteristics of a Pneumatic Proportional Valve

Modeling and Experimental Validation of the Time Delay in a Pilot Operated Proportional Directional Valve

Research on Charactertics of Direct Drive Press Servo-valve

Actuator pressure controller for a distributed electro-hydraulic braking system

Non-line Simulation and Test Analysis of the Electro-hydraulic Proportional Valve for Heavy Vehicle Combined Brake System

The Design and Simulation Analysis of Electromechanical Double Acting Pneumatic Brake Valve

Characteristics Analysis and Control Study of a Pneumatic Proportional Valve

System modeling, experimental validation and pressure estimation of the pneumatic braking system

Research on Electronic Brake Force Distribution and Anti-Lock Brake of Vehicle Based on Direct Drive Electro Hydraulic Actuator