Abstract:A failure of the pneumatic ABS (anti-lock braking system) weakens the braking performance of commercial vehicles. It affects the driving safety of vehicles. There are four typical failure modes that include: the failure of the pilot inlet solenoid valve and pilot exhaust solenoid valve of the pressure regulator, the failure of the series dual-chamber brake valve, and the failure of the relay valve. In order to study the braking performance and the rule of vehicles under the failure modes of the pneumatic ABS, the co-simulation model of the pneumatic ABS of the commercial vehicle was established based on AMESim and Simulink softwares. The gas path subsystem of the pneumatic ABS and the vehicle model were built based on AMESim. The controller was established based on Simulink/Stateflow. The data were transmitted between the AMESim and Simulink software by using the data interface block. The co-simulation model was validated by tests. The results showed that the maximum error of the braking deceleration is 13.51%. The model can simulate the braking process of the vehicle well. Based on this, the four typical failure modes of the pneumatic ABS were simulated, and the influences of different failure modes on the braking ability were analyzed. The influence of failure ratio on braking distance in four modes was obtained. It can be seen from the simulation results that the failure of the pilot inlet solenoid valve and the pilot exhaust solenoid valve of the pressure regulator cause the wheel lock. The failure of the lower chamber of the brake valve and the failure of the relay valve have a great influence on the braking distance.

Pneumatic Electronic Assistant Brake Device Based on High-Speed On/off Valve

Pneumatic electronic braking assistance system using high-speed valves

Electronically Assisted Braking System for Vehicles Based on a High-Speed On/off Valve

An Experimental Study on Hysteresis Characteristics of a Pneumatic Braking System for a Multi-Axle Heavy Vehicle in Emergency Braking Situations

Model And Optimal Design Of Pneumatic High-Speed On/Off Valve

Simulation and Experimental Investigation on Pressure Dynamics of Pneumatic High-Speed On/off Valves

Design and Simulation of a High Pressure Proportional Pneumatic Pressure Reducing Valve

Pneumatic Brake Pressure Control For Electric Vehicle Based On High Speed On/Off Solenoid Valve

Design and Simulation of Pneumatic Proportional Extra-High Pressure Valve

Modeling, Control And Test Of A Novel Electronic Pneumatic Brake System

Modeling and Adaptive Control of the Electro-Hydraulic Braking System of Low-Floor Vehicle

A Pneumatic Control Method for Commercial Vehicle Electronic Brake System Based on EPV Module

The Design and Simulation Analysis of Electromechanical Double Acting Pneumatic Brake Valve

System modeling, experimental validation and pressure estimation of the pneumatic braking system

Actuator pressure controller for a distributed electro-hydraulic braking system

Pneumatic ABS Modeling and Failure Mode Analysis of Electromagnetic and Control Valves for Commercial Vehicles

Vehicle Braking Force Distribution with Electronic Pneumatic Braking and Hierarchical Structure for Commercial Vehicle

Adaptive Cruise Control System of Commercial Vehicle Based on Dual-mode Actuators

Non-line Simulation and Test Analysis of the Electro-hydraulic Proportional Valve for Heavy Vehicle Combined Brake System

Design and Verification of Linear High-speed On-off Valve

Research on the Characteristics of a Pneumatic Proportional Valve