Abstract:This paper proposes a sensing system that utilizes a fiber-optic Fabry-Perot etalon (FPE) interferometric sensor and a narrowband distributed feedback (DFB) laser for dual parametric measurements of dynamic and static pressure. As the pressure signal passes through the central opening of the rigid FPE sensor, the pressure causes a change in the refractive index of the air in the sensor cavity, which in turn causes a change in the optical path difference (OPD) rather than the traditional pressure-induced mechanical displacement. Even though the wavelength tuning range of DFB lasers is only a few hundred pm, the appropriate cavity length of the FPE sensor ensures it can always cover a complete spectral period. Ensuring that the wavelength of the DFB laser is fixed within the linear region of the sensor spectrum will lead to time-varying alternating current (AC) intensity signals caused by acoustic waves. The cross-correlation algorithm is a high-precision method for absolute cavity length interrogation that can be used to obtain the OPD of the sensor and determine the static pressure parameters. The experimental results demonstrate a 53 dB signal-to-noise ratio (SNR) at 1 kHz acoustic pressure, along with an acoustic sensitivity of 4.025 V/Pa and a pressure sensitivity of 15.8 nm/kPa for static pressure ranging from 0 kPa to 70 kPa. Additionally, the full-phase demodulation advantage of the cross-correlation algorithm ensures an OPD resolution within 2.5 nm, even when the wavelength tuning range of the narrowband DFB laser used is less than 1 nm. The proposed dual parameter measurement scheme relies solely on a single FPE sensor, simplifying the system structure and reducing costs, and offers a competitive solution for dual parameter measurement of acoustic and static pressure in aerospace.

Intensity Demodulation Based Fiber Sensor for Dynamic Measurement of Acoustic Wave and Lateral Pressure Simultaneously

Passively Mode-Locked Multi-Longitudinal Mode Fiber Laser Sensor for Acoustic Pressure Measurement

High-sensitivity Fiber Optic Acoustic Sensors

Dual Parameter Measurement System for Dynamic and Static Pressure Based on a Fiber-Optic FPE Sensor

An Acoustic Sensor Based on Active Fiber Fabry-Pérot Microcavities

Passively Mode-Locked Fiber Laser Sensor for Acoustic Pressure Sensing

Intensity Demodulation-Based Acoustic Sensor Using Dual Fiber Bragg Gratings And A Titanium Film

High Sensitivity and High Stability Dual Fabry-Perot Interferometric Fiber-Optic Acoustic Sensor Based on Sandwich-Structure Composite Diaphragm

An Optical Fiber Pressure Sensor Based on F-P Interferometry and Intensity Demodulation

Dual-Parameter Active Fibre Sensor Based On Modal Interference In Few-Mode Fibres

Simultaneous measurement of acoustic pressure and temperature using a Fabry-Perot interferometric fiber-optic cantilever sensor

Simultaneous Measurement Of Temperature, Hydrostatic Pressure And Acoustic Signal Using A Single Distributed Bragg Reflector Fiber Laser

Diaphragm-type Fiber-Optic Interferometric Acoustic Sensor

Phase Demodulation of Short-Cavity Fabry–Perot Interferometric Acoustic Sensors with Two Wavelengths

A Fiber Optic Ultrasonic Sensor Using Polarization-maintaining Fiber for Partial Discharge Monitoring

Dual fiber Bragg gratings configuration-based fiber acoustic sensor for low-frequency signal detection

High-Sensitivity Fabry-Perot Interferometric Acoustic Sensor for Low-Frequency Acoustic Pressure Detections

Multiplexing Fiber-Optic Fabry-Perot Acoustic Sensors Using Self-Calibrating Wavelength Shifting Interferometry

Fiber-Optic Michelson Interferometric Acoustic Sensor Based on a PP/PET Diaphragm

Fabry-Perot Fiber Pressure Sensor Based on White Light Interferometry and Intensity Demodulation Method

Demodulation of Diaphragm Based Fiber-Optic Acoustic Sensor Using with Symmetric 3×3 Coupler