Abstract:In the present work, we prepared nylon 6 crystals via crystallization of nylon from phosphoric acid by using the vapors of ammonium hydroxide as a precipitation regent. Both XRD and FTIR results demonstrate that the obtained nylon 6 sample exhibit characteristic peaks of nylon 6 in gamma form. In addition, treatment of nylon 6 in boiling water for half an hour followed by FTIR and XRD characterization shows that the obtained nylon 6 sample is in gamma form rather than in meta-stable b form. DSC characterization indicates that the nylon 6 sample exhibits two melting peaks (213 and 220 degrees C) when the sample is heated at a heating rate of 10 degrees C x min(-1). The reason for this phenomenon is that the nylon 6 sample has different lamellar thickness. To investigate the thermal behavior of the nylon 6 sample, the sample underwent the following thermal treatment procedure. First, the sample was heated to a pre-set temperature (T(s)) and kept at that temperature for an hour. Subsequently, the sample was cooled down to 100 degrees C at a cooling rate of 1 degrees C x min(-1), and then cooled down to room temperature at a cooling rate of 10 degrees C x min(-1). The treated samples were characterized by FTIR and DSC method. Experimental results show that the treated nylon 6 samples exhibit different crystalline behavior. When T. ranges from 130 to 160 degrees C, no significant changes were observed. When T(s) is 170 degrees C, a small fraction nylon 6 crystals is destroyed and recrystallized into thin lamellae in a form. As a result, a pre-melting peak appears in DSC result. The pre-melting peak moves to higher temperature and its peak area increases significantly upon increasing T(s) from 170 to 198 degrees C. When T(s) amounts to 200 degrees C, the pre-melting peak and the melting peaks 213 degrees C merge into one melting peak and two melting peaks are observed at 212 and 220 degrees C in the DSC results. FTIR spectra indicate that significant amount of crystalline nylon 6 in a form appears but the majority of crystalline phase of the sample is still gamma phase. As T(s) increases from 200 to 209 degrees C, the melting peak at lower temperature moves to higher temperature with increasing its peak area. On the other hand, the melting peak at 220 degrees C decreases in intensity but does not show any peak shift. As T(s) reaches 209 degrees C, the two melting peaks merge into one peak and FTIR results demonstrate that nylon 6 in a form becomes dominate phase in the sample. In the whole heat-treatment process, the gamma phase nylon 6 sample began to transform to a phase at the heat-treatment temperature of 170 degrees C, which is far below the melting point of the original sample (221 degrees C). This is different from the results reported in the literature, which state that gamma phase nylon 6 will not transform to alpha-phase until nylon is melt.

Thermo-oxidative Degradation of Nylon 1010 Films: Colorimetric Evaluation and Its Correlation with Material Properties

Effect of Thermal Oxidative Aging on the Crystallization Behavior and Properties of Nylon-6

Structure Evolution and Properties Enhancement of Polyamide‐6/polyamide‐1010 Films under Uniaxial and Biaxial Stretching

INFLUENCE OF THERMAL TREATMENT ON CRYSTAL MELTING BEHAVIOR AND CRYSTAL STRUCTURE OF NYLON 6 AND POLYAMIDE BLOCKCOPOLYMER/NYLON 6 BLENDS

A Novel Aging Evaluation Method of Nylon

A Kinetic Study of the Thermal Degradation of Nylon-6/Attapulgite Nanocomposites

A near infrared spectroscopic study of temperature-induced changes of crystalline domains in a nylon 1010 sample

Physics and Chemistry-Based Constitutive Modeling of Photo-Oxidative Aging in Semi-Crystalline Polymers

Phase stability and melting behavior of the α and γ phases of nylon 6

Measurements to Characterise the Uniaxial Orientation in Nylon 6-6 Fibres Caused by Thermal Treatments

Thermal Aging of Polypropylene Nanocomposites

Effects of thermo-oxidative aging on chain mobility, phase composition, and mechanical behavior of high-density polyethylene

Deterioration of polypropylene/silicon dioxide nanocomposites before oxidative degradation

Experimental XPS Investigation of Thermal Decomposition of Polypropylene

Effect of Free Radicals induced by thermal aging on electrical and optical properties of BOPP film for capacitors

A Novel In-Situ Aging Evaluation Method by FTIR and the Application to Thermal Oxidized Nitrile Rubber

Investigation of Thermal Behaviors of Γ-Form Nylon 6 Prepared by Ammonia Vapor from Phosphoric Acid Solutions

Degradation of PVDF-Coated Fabrics after Engineering Applications: Correlations between Surface Microstructure, Physical Properties, and Mechanical Properties Based on Statistical Analysis

Thermal Conductivities of Nylon Thin Films Measured by ISO 11357-8 Method

Morphological-Studies Of Oriented Films Obtained From Aromatic Polyester Fractions

Non-isothermal crystallization and thermal degradation studies on nylons 7,10 and 10,7 as isomeric odd-even and even-odd polyamides