Abstract:Purpose – The purpose of this paper is to build a flow stress model and microstructure evolution models which can be used to fulfill the multi-physics prediction of hot forging process, in this way the process design can be virtually verified and optimized. This is especially crucial for micro-alloyed steel forging which microstructure determines the component properties, since the downstream quenching is usually not needed. Design/methodology/approach – First, hot compression tests have been completed; second, experimental data are used to build the flow stress model and models for microstructure evolution; third, programming has been finished to integrate the proposed models into the commercial finite element method (FEM) code; fourth, case study is conducted to simulate multi-stage hot forging process of micro-alloyed steel F38MnV piston; and fifth, simulation results are validated by experiment. Findings – First, simulation results in grain size and phase volume fraction are in well agreement with experimental ones; second, the austenite grain is dramatically refined by the dynamic recrystallization in pre-forging process and static recrystallization in the two intervals has no obvious change during the following final forging and cooling above the Ae3 temperature; third, during the cooling process below the Ae3 temperature, ferrite and pearlite transformation begin from the thin skirt to the thick skirt and piston bottom because of different cooling speeds at different areas. Originality/value – First, flow stress model, dynamic recrystallization model, static recrystallization model, austenite grain growth model and phase transformation models are established for a micro-alloyed steel; second, the multi-physics FEM simulation of multi-stage hot forging of industrial piston has been conducted and verified by experiment, which show good agreement.

Three-dimensional Numerical Simulation and Experimental Analysis of Austenite Grain Growth Behavior in Hot Forging Processes of 300M Steel Large Components

Modeling and Simulation of Austenite Grain Evolution for Heavy Forging Steel 30cr2ni4mov Undergoing Hot Deformation

An Overall Simulation of Austenite Grain Evolution for Heavy Forgings During Heating and Hot Deformation

A Numerical Simulation of Microstructure Evolution of IN718 Alloy During Multi-step Forging

Numerical simulation of grain refinement of 7075 aluminum alloy in forge processing

Numerical simulation and experimental validation of microstructure evolution during the upsetting process of a large size martensitic stainless steel forging

Numerical Prediction on Microstructure Evolution for Multi-Stage Hot Forging of Micro-Alloyed Piston

Numerical Simulation of Process and Grain Size for Large-Sized Aluminum Alloy 7050 Forging

Microstructural modeling and numerical simulation of multi-physical fields for martensitic stainless steel during hot forging process of turbine blade

Numerical simulation of microstructure evolution of flange axle during hot forging

Microstructure simulation and experiment investigation of dynamic recrystallization for ultra high strength steel during hot forging

Microstructure evolution modelling of heavy forging steel 30Cr2Ni4MoV during hot deformation

3D Finite Element Simulation of Microstructure Evolution in Blade Forging of Ti-6Al-4V Alloy Based on the Internal State Variable Models

Effects of Different Forging Processes on Microstructure Evolution for 316LN Austenitic Stainless Steel

Investigation and Modeling of Austenite Grain Evolution for a Typical High-strength Low-alloy Steel During Soaking and Deformation Process

Numerical Simulation of Microstructure Evolution During Continuous Hot Rolling Process of GCr15 Steel Rod

Austenite Grain Growth of SA508-3 Steel in Heating Process

Modeling the Effects of Processing Parameters on Dynamic Recrystallization Behavior of Deformed 38mnvs6 Steel

Austenite grain growth model for 30Cr2Ni4MoV steel during heating process and its application in heating specification for heavy forging

Effect of Hot Deformation Parameters on Heat-Treated Microstructures and Mechanical Properties of 300M Steel

Physical and Numerical Simulations of Closed Die Hot Forging and Heat Treatment of Forged Parts