Abstract:It has been proven that ultrasound irradiation can enhance the rate of heat transfer processes. The objective of this work was to study the heat transfer phenomenon, mainly the heat exchange at the surface, as affected by ultrasound irradiation around a stationary copper sphere (k=386Wm−1K−1, Cp=384Jkg−1K−1, ρ=8660kgm−3) during cooling. The sphere (0.01m in diameter) was immersed in an ethylene glycol–water mixture (−10°C) in an ultrasonic cooling system that included a refrigerated circulator, a flow meter, an ultrasound generator and an ultrasonic bath. The temperature of the sphere was recorded using a data logger equipped with a T-type thermocouple in the center of the sphere. The temperature of the cooling medium was also monitored by four thermocouples situated at different places in the bath. The sphere was located at different positions (0.02, 0.04 and 0.06m) above the transducer surface of the bath calculated considering the center of the sphere as the center of the reference system and was exposed to different intensities of ultrasound (0, 120, 190, 450, 890, 1800, 2800, 3400 and 4100Wm−2) during cooling. The frequency of the ultrasound was 25kHz. It was demonstrated that ultrasound irradiation can increase the rate of heat transfer significantly, resulting in considerably shorter cooling times. Higher intensities caused higher cooling rates, and Nu values were increased from about 23–27 to 25–108 depending on the intensity of ultrasound and the position of the sphere. However, high intensities of ultrasound led to the generation of heat at the surface of the sphere, thus limiting the lowest final temperature achieved. An analytical solution was developed considering the heat generation and was fitted to the experimental data with R2 values in the range of 0.910–0.998. Visual observations revealed that both cavitation and acoustic streaming were important for heat transfer phenomenon. Cavitation clouds at the surface of the sphere were the main cause of heating effect. The results showed that closer distances to the transducer surface showed higher cooling rates. On the other hand, despite having a bigger distance from the transducer, when the sphere was located close to the gas–liquid interface the enhancement factor of heat transfer was higher. Ultrasound irradiation showed promising effect for the enhancement of convective heat transfer rate during immersion cooling. More investigations are required to demonstrate the behavior of ultrasound assisted heat transfer and resolve the proper way of the application of ultrasound to assist the cooling and/or freezing processes.

Experimental Study of the Ultrasonic Effect on Heat Transfer Inside A Horizontal Mini-Tube in the Laminar Region

Saturated Boiling Heat Transfer under Ultrasound

Experimental study of heat transfer performance in rectangular microchannels enhanced by ultrasound

Experimental study on heat transfer and resistance of round tube with tube sheet under ultrasonic action

Experimental study on thermal and friction characteristics of liquid flow across a heating cylinders under low-frequency ultrasound

Experimental investigation of flow boiling heat transfer enhancement under ultrasound fields in a minichannel heat sink

Experimental study of the effects of ultrasound on the heat transfer enhancement in a 3D-printed minichannel heat sink

Influence of ultrasound on heat transfer of copper tubes with different surface characteristics in sub-cooled boiling

Experimental study on inlet turbulent flow under ultrasonic vibration: Pressure drop and heat transfer enhancement

Heat transfer enhancement of water flow over a heating flat plate using 20 kHz ultrasonic waves irradiated from submerged horn-type transducer

Theoretical and Experimental Analyses of Two-Phase Flow Condensation Heat Transfer Inside the Horizontal Micro-Fin Tube

Experimental Evaluation on Characteristics of a Falling-Film Flow on the Horizontal Tube Subject to Ultrasonic Field

Experimental Study on Heat Transfer Enhancement of Water-water Shell-and-Tube Heat Exchanger Assisted by Power Ultrasonic

Experimental and Numerical Studies of Liquid Flow and Heat Transfer in Microtubes

Louvered Fin-and-Flat Tube Compact Heat Exchanger under Ultrasonic Excitation

The Effect of Ultrasound Irradiation on the Convective Heat Transfer Rate During Immersion Cooling of a Stationary Sphere.

Flow boiling heat transfer enhancement under ultrasound field in minichannel heat sinks

Experimental Investigation on Heat Transfer of Supercritical Water Flowing in a Horizontal Tube with Axially Non-Uniform Heating

A Visual Experimental Study on Surface Temperature Field in Stainless Steel Microtube

Effects of Processing Parameters on the Convective Heat Transfer Rate During Ultrasound Assisted Low Temperature Immersion Treatment of a Stationary Sphere

Experimental and Numerical Investigation on Heat Transfer of Ultra-Supercritical Water in Vertical Upward Tube under Uniform and Non-Uniform Heating