Abstract:The flow condensation heat transfer coefficient of R134a inside two helical micro-fin tubes with outer diameter of 6.35 mm and helical angles of 18o and 28o respectively were experimentally studied at a high mass flux ranging from 500 to 1100 kg m−2 s−1. The condensation temperatures are 35°C, 40°C and 45°C, and the vapor qualities ranges from 0.95 to 1.00 at the inlet section and from 0.00 to 0.05 at the outlet section. Experimental results show that there are annular and intermittent flow regimes inside the tube under experimental conditions, the ratio of annular flow region to the total heat transfer region is about 70%. The liquid film flow changes from rotational flow to coexistence of rotational and horizontal flows when the vapor quality is 0.475±0.08, 0.486±0.06 and 0.521±0.05, respectively and the corresponding saturation temperature is 35°C, 40°C and 45°C. Based on the experimental data, the heat transfer coefficient increases with increasing mass flux and fin helical angle, and with decreasing saturation temperature and Reynolds number of cooling water. In addition, the heat transfer coefficient of annular flow is greater than that of intermittent flow, in other words, the heat transfer coefficient increases with increasing vapor quality. The heat transfer coefficient obtained at high mass flux was compared with the calculated data of some published correlations used at low mass flux. It was found that most correlations underestimate the experimental heat transfer coefficient inside the micro-fin tube, and these prediction deviation increases with increasing mass flux and fin helical angle. By introducing some dimensionless numbers as well as considering the flow mechanism of liquid film inside the tube, two heat transfer coefficient correlations were proposed based on the experimental data. The ratio of liquid film thickness to fin height was used to characterize whether the liquid film flow is rotational flow or coexistence of rotational and horizontal flows in the proposed correlation, which shows a better prediction accuracy with a mean deviation of less than 7.3%.

A Visual Experimental Study on Surface Temperature Field in Stainless Steel Microtube

Experimental Study on Axial Wall Heat Conduction for Convective Heat Transfer in Stainless Steel Microtube

An Experimental Investigation on Axial Heat Flux of Wall in Microtubes

Experimental Study on Influence of Axial Conductive Heat on Convective Heat Transfer in Micro Steel Tube

Experimental and Numerical Studies of Liquid Flow and Heat Transfer in Microtubes

Study on Heat Transfer Characteristics in Microtube under Heating of Constant Heat Flux

An Experimental Investigation of Single-Phase Heat Transfer in 0.045mm to 0.141mm Microtubes

Experimental study on the heat transfer characteristic in quartz microtube under heating of constant temperature

EXPERIMENTAL STUDY OF LIQUID FLOW AND HEAT TRANSFER IN MICROTUBES

Theoretical and Experimental Analyses of Two-Phase Flow Condensation Heat Transfer Inside the Horizontal Micro-Fin Tube

Experimental Investigation on Flow and Heat Transfer in Rough Microtube

Experimental Study and Analysis About Flow and Heat Transfer in Micro-tubes

Experimental measurement of inner wall average temperature of microtubes

Experimental Study on Flow and Heat Transfer in a 19.6-Μm Microtube

Experimental Study of Condensation Heat Transfer of R134a Inside the Micro-Fin Tubes at High Mass Flux

Investigation of Convective Heat Transfer with Liquids in Microtubes

Experimental Investigation On Flow Condensation Heat Transfer In Microtube

Numerical Studies of Simultaneously Developing Laminar Flow and Heat Transfer in Microtubes with Thick Wall and Constant Outside Wall Temperature

An Experimental Study of Flow and Heat Transfer in a 19.6μm Inner Diameter Quartz Microtube

Transitional And Turbulent Convective Heat Transfer Of Compressible Gas Flows Through Microtubes

The experimental research on microtube heat transfer and fluid flow of distilled water