Abstract:Experimental and numerical studies were conducted to reveal the flow and heat transfer characteristics of liquid laminar flow in microtubes. Both the smooth fused silica and rough stainless steel microtubes were used with the hydraulic diameters of 50–100μm and 373–1570μm, respectively. For the stainless steel tubes, the corresponding surface relative roughness was 2.4%, 1.4%, 0.95%. The experiment was conducted with deionized water at the Reynolds number from 20 to 2400. The experimental data revealed that the friction factor was well predicted with conventional theory for the smooth fused silica tubes. For the rough stainless steel tubes, the friction factor was higher than the prediction of the conventional theory, and increased as the surface relative roughness increased. The results also confirmed that the conventional friction prediction was valid for water flow through microtube with a relative surface roughness less than about 1.5%. The experimental results of local Nusselt number distribution along the axial direction of the stainless steel tubes do not accord with the conventional results when Reynolds number is low and the relative thickness of the tube wall is high. The numerical study reveals that the large ratio of wall thickness over tube diameter in low Reynolds number region causes significant axial heat conduction in the tube wall, leading to a non-linear distribution of the fluid temperature along the axial direction. The axial heat conduction effect is gradually weakened with the increase of Reynolds number and the decrease of the relative tube wall thickness and thus the local Nusselt number approaches the conventional theory prediction.

An Experimental Investigation on Axial Heat Flux of Wall in Microtubes

Experimental Study on Axial Wall Heat Conduction for Convective Heat Transfer in Stainless Steel Microtube

A Visual Experimental Study on Surface Temperature Field in Stainless Steel Microtube

Effects of Axial Heat Conduction in the Wall on Convection in Microtubes

Experimental Study on Influence of Axial Conductive Heat on Convective Heat Transfer in Micro Steel Tube

Experimental and Numerical Studies of Liquid Flow and Heat Transfer in Microtubes

Numerical Studies of Simultaneously Developing Laminar Flow and Heat Transfer in Microtubes with Thick Wall and Constant Outside Wall Temperature

Experimental measurement of inner wall average temperature of microtubes

An Experimental Investigation of Single-Phase Heat Transfer in 0.045mm to 0.141mm Microtubes

Investigation of Evaluation Criterion of Axial Wall Heat Conduction in Tube Laminar Flow and Heat Transfer

Experimental Investigation on Flow and Heat Transfer in Rough Microtube

Experimental Study on Flow and Heat Transfer in a 19.6-Μm Microtube

Investigation of Convective Heat Transfer with Liquids in Microtubes

EXPERIMENTAL STUDY OF LIQUID FLOW AND HEAT TRANSFER IN MICROTUBES

Experimental Investigation On Flow Condensation Heat Transfer In Microtube

Wall effect of gas laminar heat transfer in microtubes

Study on Heat Transfer Characteristics in Microtube under Heating of Constant Heat Flux

Experimental Study and Analysis About Flow and Heat Transfer in Micro-tubes

Wall temperature effect on mass flux in a short micro-tube

Effect of Axial Heat Conduction on Heat Transfer in Triangular Silicon Microchannels

Effect of Axial Heat Conduction on Heat Transfer in Micro-Channels