Abstract:H doping can enhance the performance of ZnO thin-film transistors (TFTs) to a certain extent, and the design of double active layers is an effective way to further improve a device’s performance. However, there are few studies on the combination of these two strategies. We fabricated TFTs with ZnO:H (4 nm)/ZnO (20 nm) double active layers by magnetron sputtering at room temperature, and studied the effect of the hydrogen flow ratio on the devices’ performance. ZnO:H/ZnO-TFT has the best overall performance when H2/(Ar + H2) = 0.13% with a mobility of 12.10 cm2/Vs, an on/off current ratio of 2.32 × 107, a subthreshold swing of 0.67 V/Dec, and a threshold voltage of 1.68 V, which is significantly better than the performance of single active layer ZnO:H-TFTs. This exhibits that the transport mechanism of carriers in double active layer devices is more complicated. On one hand, increasing the hydrogen flow ratio can more effectively suppress the oxygen-related defect states, thus reducing the carrier scattering and increasing the carrier concentration. On the other hand, the energy band analysis shows that electrons accumulate at the interface of the ZnO layer close to the ZnO:H layer, providing an additional path for carrier transport. Our research exhibits that the combination of a simple hydrogen doping process and double active layer construction can achieve the fabrication of high-performance ZnO-based TFTs, and that the whole room temperature process also provides important reference value for the subsequent development of flexible devices.

Improved Negative Bias Illumination Stability and Thermal Stability of HfZnSnO/ZnSnO Thin-Film Transistor Using Double-Channel Structure by Cosputtering

Solution-processed Coplanar Top-Gate ZnInSnO Thin Film Transistors and Bias Stability

The Influence of the Hafnium Doping on Negative Bias Stability in Zinc Oxide Thin Film Transistor

Sol-gel Indium-Zinc-tin-oxide Thin Film Transistor Pixel Array with Superior Stabilityunder Negative Bias Illumination Stress

Improved Environmental Stability of InSnO Thin-Film Transistor by Interface Engineering

High-Performance Thin-Film Transistors with ZnO:H/ZnO Double Active Layers Fabricated at Room Temperature

Improvement in Instability of Transparent ALD ZnO TFTs under Negative Bias Illumination Stress with SiO/AlO Bilayer Dielectric

Simultaneous Enhancement of Electrical Performance and Negative Bias Illumination Stability for Low-Temperature Solution-Processed SnO2 Thin-Film Transistors by Fluorine Incorporation

Achieving High Performance of ZnSnO Thin-Film Transistor via Homojunction Strategy

Back-End-of-Line Compatible InSnO/ZnO Heterojunction Thin-Film Transistors With High Mobility and Excellent Stability

P‐1.9: Enhanced Stability Under Positive Bias Temperature Stress of Ln‐Doped InZnO Thin Film Transistors Fabricated with Back‐channel‐etch Structure

Improvement of the Long-Term Stability of ZnSnO Thin Film Transistors by Tungsten Incorporation Using a Solution-Process Method

Stability Enhancement of Low Temperature Thin-Film Transistors with Atomic-Layer-Deposited Zno:Al Channels

Enhanced Stability Performance of Transparent Ozone ALD ZnO Thin-Film Transistors with SiAlOX Dielectric

Enhanced Stability under Positive Bias Temperature Stress of Ln-Doped Inzno Thin Film Transistors Fabricated with a Back-Channel-Etch Structure

High-performance Fully Transparent Al–Sn–Zn–O Thin-Film Transistors Using Double-Channel Structures

High-Performance Al–Sn–Zn–O Thin-Film Transistor with a Quasi-Double-Channel Structure

P-19: Dual Active Layer Structure of Nitrogen Doped Amorphous InSnZnO Thin-Film Transistors for Negative Gate Bias Stability Improvement

Praseodymium-Doped In-Sn-Zn-O TFTs With Effective Improvement of Negative-Bias Illumination Stress Stability

Solution-processed High Stability Top-Gate W and F Co-Doped ZnSnO Thin Film Transistors

Effect of Indium Doping on Bias Stability in Dual-Target Co-Sputtering InZnSnO Thin-Film Transistors