Abstract:New time-based readout (TBR) electronics has been developed and evaluated for its performance and application for PET detectors. It consists of a leading edge (LE) timing threshold for timing pickoff that provides a signal timing t1; a charge integration followed by a constant discharge between two specific timings t2 and t3 that are used to directly measure the signal energy. The timing-walk error caused by LE from signals of different amplitudes can be measured with t1 as a function of different signal amplitudes that is proportional to the time difference between t2 and t3. With this pre-calibration, timing-walk error can be accurately corrected. Therefore, both signal timing and energy can be accurately measured with digital timing signals without using CFD and ADC. These timing signals were controlled and in principle can be measured by an FPGA that can apply many signal logic and data correction algorithms. A single channel discrete component TBR circuit has been implemented in PC board, and 8-channel ASIC chips have been developed for feasibility evaluations and PET detector applications. Initial functionality and performance evaluations have been conducted. Signal amplitude measurement accuracy and linearity are very good; the measured timing accuracy from a pulse is the same as a standard CFD and reaches to similar to 100 ps resolution with the test setup. Both suitable energy and coincidence timing resolutions (similar to 17% and similar to 1.0-2.0 ns) were achieved with PMT or Solid-State PM (SSPM) array based PET detectors. Initial studies to acquire flood source crystal identification map has demonstrated the advantages of applying parallel readout with TBR electronics that read out and process signals from each pixel of SSPM array independently. With its relatively simple circuit and low cost, TBR electronics is expected to provide suitable front-end signal readout electronics for compact photon detectors such as SSPM array that require large number of output channels and demand high performance in energy and timing.

A New Solution of Time Synchronization in All-Digital Pet Based on Tdc

A Scalable Synchronized Timing System For Digital Pet

Energy And Timing Measurement Of A Pet Detector With Time-Based Readout Electronics

Performance Evaluation of Time Distribution over SerDes-based Interconnections for PET System

Design high precision time keeping clock system based on Time Digital Convert

Energy and Timing Measurement with Time-Based Detector Readout for PET Applications: Principle and Validation with Discrete Circuit Components.

Trans-Pet: Towards Plug and Imaging Coincidence Measurement

Timing Optimization For Digital Pet Detector Module Based On Fpga-Only Mvt Digitizers

Sub-Detector Unit Timing Calibration for Brain Pet Based on L1-Norm Constraint

A Simple Smart Time-to-digital Convertor Based on Vernier Method for a High Resolution LYSO MicroPET

Design of the Time Measurement Circuit, Single Data Frame Sorting, and Packaging Logic of a TOF PET System

Study of Time Resolution by Digital Methods with a DRS4 Module

Front-End Electronics Design Based on Vernier Method for A High Resolution Micropet

A High-Resolution Multi-Channel Time-To-Digital Converter (Tdc) For High-Energy Physics And Biomedical Imaging Applications

Initial Implementation of All-Digital PET DAQ System

A high precision TDC based on a multi-phase clock

A 71Ps-Resolution Multi-channel CMOS Time-to-Digital Converter for Positron Emission Tomography Imaging Applications

Study of time resolution by digital methods with DRS4 system

Design and performance of a 16-channel coarse-fine TDC prototype ASIC

Timing Optimization with Position Information for TransPET

A Simple All-Digital PET System